McCulloch MCT2027 user manual Operating Insyructions, Connect the Cord, Trimmer Operation

4 - OPERATING INSYRUCTIONS

4-1. CONNECT THE CORD

1.Ensure the cord is NOT plugged into a receptacle before this procedure.

2.Make a loop with 8″ - 10″ (20 - 25cm) of the end of the extension cord.

3.Place the loop into the slot (A) under the rear handle and lock into place on the cord retainer as shown in Figure 5-1.

4.Connect the extension cord to the trimmer.

5.Plug the extension cord into a receptacle ONLY when you are ready to operate the trimmer.

4-2A

4 - OPERATING INSYRUCTIONS

6.OPERATING AS AN EDGER (Fig. 4-2D). With the unit configured as an edger, hold it so the motor is to your left side so that debris is thrown to the rear. Always use eye protection.

7.SWEEPING - DO NOT SWEEP WITH TRIMMER (Fig. 4-2E)

8.DO NOT BUMP TRIMMER ON CONCRETE. This can damage the stringhead (Figure 4-2F).

4-2F

A

4-1

4-2. TRIMMER OPERATION

1.TRIMMING / MOWING (Fig. 4-2A). Swing trimmer with a sickle-like motion from side to side. Do not tilt the stringhead during the procedure. Test area to be trimmed for proper cutting height. Keep stringhead at same level for even depth of cut.

2.CLOSER TRIMMING (Fig. 4-2B). Position trimmer straight ahead with a slight tilt so bottom of stringhead is above ground level and string contact occurs at proper cutting point. Always cut away from operator. Do not pull trimmer in toward operator.

3.FENCE/FOUNDATION TRIMMING. Approach trim- ming around chain link fences, picket fences, rock walls and foundations slowly to cut close without whip- ping string against the barrier. If the string comes in contact with rock, brick walls, or foundations, it will break or fray. If string snags fencing, it will snap off.

4.TRIMMING AROUND TREES. Trim around tree trunks with a slow approach so string does not contact bark. Walk around the tree trimming from left to right. Approach grass or weeds with the tip of the string and tilt stringhead slightly forward.

5.SCALPING (Fig. 4-2C). Scalping refers to removal of all vegetation down to the ground. To do this, tilt the stringhead to about a 30 degree angle to the left. By adjusting the handle you will have better control dur- ing this operation. Always keep a distance of 50 feet (15 meters) from other people and animals when scalping. Do not attempt this procedure if there is any chance flying debris could injure operator, other peo- ple or cause damage to property.

4-2B

4-2c

8

4-2D

4-2E

9