Sears 917.257632 owner manual Customer R, Sibilities, Engine, Transaxle Cooling, Lubrication

Page 16

Hi H IHH

I

CUSTOMER R

TO CLEAN BATTERY AND TERMINALS

Corrosion and dirt on the battery and terminals can cause the battery to "leak" power,.

•Open battery box door.

•Disconnect BLACK battery cable first then RED bat- tory cable and remove battery from tractor_,

°Wash battery with solution of four tablespoons of

baking sodato one gallon of water,, Becareful not to get the soda solution into the cells,_

•Rinse the battery with plain water and dry.

•Clean terminals and battery cable ends withwire brush until bright.

•Coat terminals with grease or petroleum jelly°

•Reinstall battery (See "INSTALL BATTERY" in the Assembly section of this manual).,

V-BELTS

Check V-belts for deteriorationand wear after 100 hours of operation and replace if necessary,, The belts are not adjustable°Replace belts if they begin to slip from wear.

TRANSAXLE COOLING

Keep transaxle free from build-up of dirt and chaff which can restrict cooling.

ENGINE

LUBRICATION

Only use high quality detergent oil rated with API service classificationSForSG. Select the oit'sSAE viscositygrade

according to your expected operating temperature_

SAE VISCOSR-Y GRADES

mz

4

=F

-20"

0=

30" 32° '40°

60°

80'

100_'

 

 

L

 

 

TEMPERATURE RANGE ANTIcIPATEO BEFORE. NEXT OIL CHANGE,

FIG. 13

NOTE: Although multi-viscosity oils (5W30, 10W30 etc.) improve starting in cold weather, these multi-viscosity oils will result in increased oil consumption when used above 32°F. Check your engine oillevel more frequently to avoid possible engine damage from running low on oil.

Change the oit after the first two hours of operation and every 25 hours thereafter'or at least once a year if the tractor is not used for 25 hours in one year.

Check the crankcase oil level before starting the engine and after each eight (8) hours of operation. Tighten oil fill cap/dipsticksecurety each time you check the oil level.

TO CHANGE ENGINE OIL (See Figs. 13 and 14)

Determine temperature range expected before oilchange. All oil must meet API service classification SF or SG.

°Be sure tractor'is on level surface.

•Oil will drain more freely when warm.

SIBILITIES

•Catch oil in a suitable container,

°Remove oil fill cap/dipstick. Be careful not to allow dirt to enter'the engine when changing oil.

•Remove drain plug.

-After oil has drained completely, replace oil drain plug and tighten securely_

•Refill engine with oil through oil fill dipstick tube. Pour slowly. Do not overfill,. For approximate capacity see "PRODUCT SPECIFICATIONS" on page 3 of this manual.

•Use gauge on oil fill cap/dipstick for checking level Be sure dipstick cap is tightened securely for accurate reading_ Keep oil at "FULL" iine on dipstick,

OIL FILL

CAP,'DIPSTICK

OIL DRAIN PLUG

FIG. 14

AIR FILTER (See Fig. 15)

Your engine will not run properly using a dirty air filter. Clean the foam pro-cleaner after every 25 hours of opera- tion or every season. Service paper'cartridge every 100 hours of operation or every season, whichever occursfirst..

Service air cleaner more often under dusty conditions.

•Remove knob(s) and cover.

TO SERVICE PRE-CLEANER

•Slide foam pro-cleaner off cartridge° ° Wash it in liquid detergent and water.

•Squeeze it dry in a clean cloth.

•Saturate it in engine oil. Wrap it in clean, absorbent clothand squeeze to remove excess clio

°If very dirty or damaged, replace pre-cleaner,

• Reinstall pro-cleaner over cartridge.

°Reinstall cover and secure with knob(s)o

TO SERVICE CARTRIDGE

°Remove cartridge nut.

°Carefully remove cartridge to prevent debris from en- tedng carburetor'. Clean base carefully to prevent debris from entering carburetor.

•Clean cartridgebytapping gentlyon flat surface. Ifvery dirty or damaged, replace cartridge,

•Reinstall cartridge, nut, precleaner, cover and secure with knob(s)_

IMPORTANT: PETROLEUM SOLVENTS, SUCH AS

KEROSENE, ARE NOT TO BE USED TO CLEAN THE CARTRIDGE,, THEY MAY CAUSE DETERIORATION OF

THE CARTRIDGE DO NOT OIL CARTRIDGE, DO NOT USE PRESSURIZED AIR TO CLEAN OR DRY

CARTRtDGE_

16

Page 15 Page 17
Image 16
Page 15 Page 17
Contents IIIIIIIIIIIIIIIIIIIIIIrrmlllllllllll Safe Operation Practices for Ride-On Mowers ChildrenMaintenance Agreement ModelTable of Contents Engin E Maintenance PerformanceParts bag contents not shown full size Hardware PackAssembly Tools Required for AssemblyTo Removetractor from Carton Unpack CartonHOW to SET UP ,/OURTRACTOR Check Tire PressureCheck Deck Levelness Check for Proper Position of ALL BeltsChecklist Install Battery See FigsOperation HOW to USE Your Tractor To Adjust Mower Cutting Height See FigTo USE Throttle Control See Fig Stopping See FigOperation Before Starting the EngineTo Operate on Hills To TransportADD Gasoline To Start Engine See FigLubrication Chart Customer ResponsibilitiesGeneral Recommendations CheckTransaxle CoolingBattery See Fig Blade Removal See FigTo Sharpen Blade See Fig TiresCustomer R SibilitiesEngine Transaxle CoolingClean AIR Screen See Fig MufflerSpark Plugs Engine Cooling Fins See FigService and Adjustments To Install Mower See FigTo Remove Mower See Fig Mowerwill be easier to remove from the right side oftractorTo Level Mower Housing Bothfront Links Must be Equal in LengthTo Adjust Brake See Fig To Replace Mower Blade Drive BeltTo Replace Motion Drive Belt See Fig STATONARY!1 TransaxleTo Adjust Steering Wheel Alignment To Start Engine with a Weak Battery See FigFront Wheel TOE-IN/CAMBER To Remove Wheel for RepairsTo Remove Hood and Grill Assembly See Fig SE and aTo Replace Headlight Bulb Interlocks and RelaysTo Adjust Throttle Control Cable To Adjust Carburetor See FigPreliminary Setting Final SettingBattery StorageTractor Fuel SystemProblemcause CorrectionPoints ProblemCorrection Wiring Insulated Clips SolenoidWith a Special Alternator Will Change with EngineElectrical Battery 12 Volt 25 AMP KEY Part DescriptionBolt Hex Hd 1/4-20unc X 3/4 Tube PasticChassis and Enclosures Part Description 105037XDrive NO. no KEY PartDescripon KEY Part Steering Assembly 13 HP 42 Tractor --MODEL Number 127437 Seat Assembly145006 Decals Wheels & TiresEngine Optional Equipment24 fJ Repair Parts 161718 O 13 HP 42 TRACTOR- Model Number KEY Part NO. NO. DescriptionMower Retainer Dana Transaxle Model Number 13 HP 42 Tractor - Model2732 3635 KEY Part NO. no Description Jaw, Brake761 306 562308 305 337108 618 634 Briggs & Stratton Engine Model Number 28M707, Type Number222 240 356 877305 668 1044 455311 842Carburetor Overhaul KIT Gasket SET Carburetor Gasket SETBriggs & Stratton Engine Model Number 28M707, Type Number KEY Part NO. NO+ Description NO. no Page SERVmCE Notes Page Only Ride UP and Down Hill Not Across Hill Sight and Hold this Level with SKY Line or TreeFor Repair SERVICE, Call this Toll Free Number If YOU Need Repair Service or PartsPart Number Part Description

917.257632 specifications

The Sears 917.257632 is a versatile lawn tractor that has been designed to cater to homeowners looking for efficiency and ease in lawn care. This model stands out with its blend of features that make it an attractive option for anyone looking to maintain a well-manicured yard.

One of the main features of the Sears 917.257632 is its powerful engine. It is equipped with a reliable 19 horsepower engine, providing ample power to handle various tasks throughout the yard. Whether mowing the lawn, hauling materials, or towing attachments, this lawn tractor ensures consistent performance.

The tractor boasts a wide cutting deck, typically measuring around 42 inches, which allows for a broader mowing path and reduces the time spent cutting the grass. The cutting height is easily adjustable, giving users the flexibility to choose their preferred grass length, ensuring a professional-looking finish every time.

The 917.257632 features a hydrostatic transmission, offering smooth and seamless speed adjustments without the need for gear shifting. This technology enhances ease of use, allowing operators to focus on navigating the lawn rather than managing gears. The intuitive foot pedal provides effortless control, making it easier to maneuver around obstacles.

Comfort is another significant aspect of the Sears 917.257632. The tractor comes with a cushioned seat that offers ample support during longer mowing sessions, ensuring an enjoyable experience. The ergonomic steering wheel is designed for optimal handling and ease of navigation, allowing users to operate the lawn tractor with minimal fatigue.

Additionally, the Sears 917.257632 includes ample storage options, with a compartment located near the operator’s seat to store essential tools and supplies. The tractor is designed with durability in mind, featuring robust materials that withstand regular use and varied weather conditions.

Safety features are critical in this model, with mechanisms such as a blade brake that automatically stops the blades when the operator leaves the seat. This ensures peace of mind while operating the machine, particularly on uneven terrain.

In summary, the Sears 917.257632 is a well-rounded lawn tractor that combines power, comfort, and advanced technology, making it an excellent choice for homeowners seeking a reliable solution for their lawn care needs. Its diverse features and user-friendly design enhance the overall mowing experience, setting it apart in the competitive market of lawn tractors.
Top Page Image Contents