Sears 917.257632 owner manual Storage, Tractor, Fuel System, Battery, Engine OIL

Page 24

i i

illllllllllll

i

ill ill

illlll iilllllii iill ill iii

iii iii

ii illl illl illlii ij ii

STORAGE

immediately prepare your tractor for storage at the end of the season or'if the tractor will not be used for 30 days or more.

CAUTION: Never store the tractor with

gasoline in the tank inside a building where fumes may reach an open flame or spark° Allow the engine to cool before storing in any enclosure.

TRACTOR

Remove mower from tractor for winter storage° When

mower is to be stored for'a period of time, clean it thor- oughfy, remove all dirt, grease, leaves, etc_ Store in a

clean, dry area.

Clean entire tractor (See"CLEAN tNG" in the Customer Responsibilities section of this manual).

°Inspect and replace belts, if necessary (See belt re- placement instructions inthe Service and Adjustments section of this manual).

Lubricate as shown in the Customer Responsibilities section of this manual

Be sure that all nuts, bolts and screws are securely fastened_ inspect moving parts for damage, breakage and wear° Replace if necessary.

ENGINE

FUEL SYSTEM

IMPORTANT: IT IS IMPORTANT TO PREVENT GUM

DEPOSITS FROM FORMING iN ESSENTIAL FUEL SYSTEM PARTS SUCH AS CARBURETOR, FUEL FILTER,

FUEL HOSE, OR TANK DURING STORAGE. ALSO, EXPERIENCE INDICATES THAT ALCOHOL BLENDED

FUELS (CALLED GASOHOL OR USING ETHANOL OR

METHANOL) CAN ATTRACT MOISTURE WHICH LEADS TO SEPARATION AND FORMATION OF ACIDS DURING

STORAGE. ACIDIC GAS CAN DAMAGE THE FUEL SYSTEM OF AN ENGINE WHILE IN STORAGE

°Drain the fuel tank.

°Start the engine and let it run until the fuel lines and carburetor are empty°

Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

Use fresh fuel next season°

NOTE: Fuel stabilizer is an acceptable alternative in minimizing the formation of fuel gum deposits during stor- age. Add stabilizer to gasoline in fuel tank or storage container,, Always foUow the mix ratio found on stabilizer container. Run engine at least 10 minutes after adding stabilizerto aUowthestabilizerto reach the carburetor. Do riotdrain the gas tank and carburetor if using fuel stabilizer°

°Touch up all rusted or chipped paint surfaces; sand lightlybefore painting.

BATTERY

Fully charge the battery for storage.

After a period of time in storage, battery may require recharging.

To help prevent corrosion and power leakage during long periods of storage, battery cables should be disconnected and battery cleaned thoroughly(see'_ro CLEAN BATTERY AND TERMINALS" in the Cus- tomer Responsibilities section of this manual).

°After cleaning, leave cables disconnected and place cables where they cannot come in contact with battery terminals_

Be sure battery drain tube is securely attached.

°If battery is removed from tractor for storage, do not store battery directly on concrete or damp surfaces,_

ENGINE OIL

Drain oil (with engine warm) and replace with clean engine

oil (See "ENGINE" in the Customer Responsibilities section of this manual).

CYLINDERS

Remove spark plug(S)o

°Pour one ounce of oil through spark plug hole(s) into cylinder(s).

Turn ignition key to"START" position for a few seconds to distribute oil

°Replace with new spark plug(s).

OTHER

°Do not store gasoline from one season to arrothero

°Replace your'gasoline can if your can starts to rust° Rust and/or dirt in your gasoline will cause problems,

If possible, store your tractor indoors and cover it to give protection from dust and dirt°

Cover'your tractor with a suitable protective cover that

does not retain moisture. Do not use plastic. Plastic cannot breathe which allows condensation to form and

will cause your tractor to rust.

IMPORTANT: NEVER COVER TRACTOR WHILE ENGINE AND EXHAUST AREAS ARE STILL WARM.

24

Image 24
Contents IIIIIIIIIIIIIIIIIIIIIIrrmlllllllllll Safe Operation Practices for Ride-On Mowers ChildrenMaintenance Agreement ModelTable of Contents Engin E Maintenance PerformanceParts bag contents not shown full size Hardware PackAssembly Tools Required for AssemblyTo Removetractor from Carton Unpack CartonHOW to SET UP ,/OURTRACTOR Check Tire PressureCheck Deck Levelness Check for Proper Position of ALL BeltsChecklist Install Battery See FigsOperation HOW to USE Your Tractor To Adjust Mower Cutting Height See FigTo USE Throttle Control See Fig Stopping See FigOperation Before Starting the EngineTo Operate on Hills To TransportADD Gasoline To Start Engine See FigLubrication Chart Customer ResponsibilitiesGeneral Recommendations CheckTransaxle CoolingBattery See Fig Blade Removal See FigTo Sharpen Blade See Fig TiresCustomer R SibilitiesEngine Transaxle CoolingClean AIR Screen See Fig MufflerSpark Plugs Engine Cooling Fins See FigService and Adjustments To Install Mower See FigTo Remove Mower See Fig Mowerwill be easier to remove from the right side oftractorTo Level Mower Housing Bothfront Links Must be Equal in LengthTo Adjust Brake See Fig To Replace Mower Blade Drive BeltTo Replace Motion Drive Belt See Fig STATONARY!1 TransaxleTo Adjust Steering Wheel Alignment To Start Engine with a Weak Battery See FigFront Wheel TOE-IN/CAMBER To Remove Wheel for RepairsTo Remove Hood and Grill Assembly See Fig SE and aTo Replace Headlight Bulb Interlocks and RelaysTo Adjust Throttle Control Cable To Adjust Carburetor See FigPreliminary Setting Final SettingBattery StorageTractor Fuel SystemProblemcause CorrectionProblem PointsCorrection Wiring Insulated Clips SolenoidWith a Special Alternator Will Change with EngineElectrical Battery 12 Volt 25 AMP KEY Part DescriptionBolt Hex Hd 1/4-20unc X 3/4 Tube PasticChassis and Enclosures Part Description 105037XDrive KEY Part NO. noDescripon KEY Part Steering Assembly 13 HP 42 Tractor --MODEL Number Seat Assembly 127437145006 Decals Wheels & TiresOptional Equipment Engine24 fJ Repair Parts 161718 O 13 HP 42 TRACTOR- Model Number KEY Part NO. NO. DescriptionMower Retainer 13 HP 42 Tractor - Model Dana Transaxle Model Number2732 3635 KEY Part NO. no Description Jaw, Brake761 306 562308 305 337108 618 634 Briggs & Stratton Engine Model Number 28M707, Type Number222 240 356 877305 668 1044 455311 842Carburetor Overhaul KIT Gasket SET Carburetor Gasket SETBriggs & Stratton Engine Model Number 28M707, Type Number KEY Part NO. NO+ Description NO. no Page SERVmCE Notes Page Only Ride UP and Down Hill Not Across Hill Sight and Hold this Level with SKY Line or TreeIf YOU Need Repair Service or Parts For Repair SERVICE, Call this Toll Free NumberPart Number Part Description

917.257632 specifications

The Sears 917.257632 is a versatile lawn tractor that has been designed to cater to homeowners looking for efficiency and ease in lawn care. This model stands out with its blend of features that make it an attractive option for anyone looking to maintain a well-manicured yard.

One of the main features of the Sears 917.257632 is its powerful engine. It is equipped with a reliable 19 horsepower engine, providing ample power to handle various tasks throughout the yard. Whether mowing the lawn, hauling materials, or towing attachments, this lawn tractor ensures consistent performance.

The tractor boasts a wide cutting deck, typically measuring around 42 inches, which allows for a broader mowing path and reduces the time spent cutting the grass. The cutting height is easily adjustable, giving users the flexibility to choose their preferred grass length, ensuring a professional-looking finish every time.

The 917.257632 features a hydrostatic transmission, offering smooth and seamless speed adjustments without the need for gear shifting. This technology enhances ease of use, allowing operators to focus on navigating the lawn rather than managing gears. The intuitive foot pedal provides effortless control, making it easier to maneuver around obstacles.

Comfort is another significant aspect of the Sears 917.257632. The tractor comes with a cushioned seat that offers ample support during longer mowing sessions, ensuring an enjoyable experience. The ergonomic steering wheel is designed for optimal handling and ease of navigation, allowing users to operate the lawn tractor with minimal fatigue.

Additionally, the Sears 917.257632 includes ample storage options, with a compartment located near the operator’s seat to store essential tools and supplies. The tractor is designed with durability in mind, featuring robust materials that withstand regular use and varied weather conditions.

Safety features are critical in this model, with mechanisms such as a blade brake that automatically stops the blades when the operator leaves the seat. This ensures peace of mind while operating the machine, particularly on uneven terrain.

In summary, the Sears 917.257632 is a well-rounded lawn tractor that combines power, comfort, and advanced technology, making it an excellent choice for homeowners seeking a reliable solution for their lawn care needs. Its diverse features and user-friendly design enhance the overall mowing experience, setting it apart in the competitive market of lawn tractors.