Sears 917.257632 HOW to SET UP ,/OURTRACTOR, Check Tire Pressure, Check Deck Levelness

Page 8

Jl

HOW TO SET UP ",/'OURTRACTOR

PREPARE BATTERY (See Fig. 2)

.......,,,,, ,,,,,,,,, ,,, ,,,

CAUTION: Wear eye and face shield.

Wash hands or clothing immediately if

Do not smoke. Fumes from charged

& acciden_Uyin contact with battew acid. battery acid are explosive.

Read the instructions included with the

battery vent caps. Always wear gloves, clothing and goggles to protect your hands, skin and eyes.

Your tractor' has a battery charging system which is sufficientfor normat use+ However, periodicchargingofthe battery with an automotive charger willextend its life.

•See instructions packed with vent caps in parts bag.

°Fill battery with acid. Fill each cell until it reaches the bottom of the vent wells. Do not overfill.

•Allow battery to stand and settle for at least thirty minutes. After standing, check the battery cell acid level+ If below the vent wells, add more acid until the correct tevei is reached+

While battery is standing (after adding acid) and later, while battery is being charged, continue with assembly of tractor+

IMPORTANT: TO MAXIMIZE THE LIFE OF YOUR

BATTERY, IT tS NECESSARY THAT THE BATTERY BE CHARGED BEFORE USE. FAILURE TO CHARGE

BATTERY CAN RESULT IN A SHORTENED BATTERY

INSTALL SEAT (See Fig. 3)

Adjust seat before tighteningadjustment bolt,

•Remove cardboard packing on seat pan+

•Place seat on seat pan and assemble shoulder boll

oAssemble adjustment bolt, iockwasherand flatwasher loosely,. Do not tighten+

•Tighten'shoulder bolt securely+

°Lower seat into operating position and sit on seat.

•Slide seat until a comfortable position is reached which

allows you to press clutch/brake pedal all the way down.

•Get off seat without moving its adjusted position.

•Raise seat and tighten adjustment bolt securely.

SEATPAN

SHOULDER \_\

BOLT

ADJUSTMENT

LIFE.

BOLT

LOCK WASHER

•Charge battery at a rate of 6 amperes for1 hour,. Use a 12 volt battery charger. Observe all safety precau- tions required for battery charging+

•Check the acid level after the battery is charged. If the acid has fallen below the correct level, add distilled or iron free water+

. Install the vent caps to cover the vent wells+ Wash the top of the batter] with water to remove any acid, then wipe dry+

°Check battery case for'leakage to make sure that no damage has occurred in harldUng+

•Dispose of excess battery acid. Neutralize acid for disposal by adding it to two gallons of water in a five gal!on plastic container. Stir with a wooden or plastic paddle while adding baking soda until the addition of more soda causes no more foaming,

•Follow instructions on how to install battery.

CUT AWAY VIEW

BATTERY

CELL ACID

LEVEL

RG. 2

8

FIG. 3

CHECK TIRE PRESSURE

The tires on your tractor were ovednflated at the factory for+ shipping purposes. Correct tire pressure is important for

best cutting performance.

•Reduce tire pressure to PSI shown in "PRODUCT SPECIFICATIONS" on page 3 of this manual.

CHECK DECK LEVELNESS

For best cuttingresults, mower housing should be properly leveled+ See 'q'OLEVEL MOWER HOUSING" in the

Service and Adjustments section of this manual.

CHECK FOR PROPER POSITION OF ALL BELTS

See the figures that are shown for replacing motion and mower blade drive belts in the Service and Adjustments section of this manual Verify that the belts are routed correctly

CHECK BRAKE SYSTEM

After you learn how to operate your tractor, check to see that the brake is properly adjusted. See "TO ADJUST BRAKE" in the Service and Adjustments section of this manual.,

Page 7 Page 9
Image 8
Page 7 Page 9
Contents IIIIIIIIIIIIIIIIIIIIIIrrmlllllllllll Safe Operation Practices for Ride-On Mowers ChildrenMaintenance Agreement ModelTable of Contents Engin E Maintenance PerformanceParts bag contents not shown full size Hardware PackAssembly Tools Required for AssemblyTo Removetractor from Carton Unpack CartonHOW to SET UP ,/OURTRACTOR Check Tire PressureCheck Deck Levelness Check for Proper Position of ALL BeltsChecklist Install Battery See FigsOperation HOW to USE Your Tractor To Adjust Mower Cutting Height See FigTo USE Throttle Control See Fig Stopping See FigOperation Before Starting the EngineTo Operate on Hills To TransportADD Gasoline To Start Engine See FigLubrication Chart Customer ResponsibilitiesGeneral Recommendations CheckTransaxle CoolingBattery See Fig Blade Removal See FigTo Sharpen Blade See Fig TiresCustomer R SibilitiesEngine Transaxle CoolingClean AIR Screen See Fig MufflerSpark Plugs Engine Cooling Fins See FigService and Adjustments To Install Mower See FigTo Remove Mower See Fig Mowerwill be easier to remove from the right side oftractorTo Level Mower Housing Bothfront Links Must be Equal in LengthTo Adjust Brake See Fig To Replace Mower Blade Drive BeltTo Replace Motion Drive Belt See Fig STATONARY!1 TransaxleTo Adjust Steering Wheel Alignment To Start Engine with a Weak Battery See FigFront Wheel TOE-IN/CAMBER To Remove Wheel for RepairsTo Remove Hood and Grill Assembly See Fig SE and aTo Replace Headlight Bulb Interlocks and RelaysTo Adjust Throttle Control Cable To Adjust Carburetor See FigPreliminary Setting Final SettingBattery StorageTractor Fuel SystemProblemcause CorrectionCorrection ProblemPoints Wiring Insulated Clips SolenoidWith a Special Alternator Will Change with EngineElectrical Battery 12 Volt 25 AMP KEY Part DescriptionBolt Hex Hd 1/4-20unc X 3/4 Tube PasticChassis and Enclosures Part Description 105037XDrive Descripon KEY Part KEY PartNO. no Steering Assembly 13 HP 42 Tractor --MODEL Number 145006 Seat Assembly127437 Decals Wheels & Tires24 fJ Optional EquipmentEngine Repair Parts 161718 O 13 HP 42 TRACTOR- Model Number KEY Part NO. NO. DescriptionMower Retainer 2732 3635 13 HP 42 Tractor - ModelDana Transaxle Model Number KEY Part NO. no Description Jaw, Brake761 306 562308 305 337108 618 634 Briggs & Stratton Engine Model Number 28M707, Type Number222 240 356 877305 668 1044 455311 842Carburetor Overhaul KIT Gasket SET Carburetor Gasket SETBriggs & Stratton Engine Model Number 28M707, Type Number KEY Part NO. NO+ Description NO. no Page SERVmCE Notes Page Only Ride UP and Down Hill Not Across Hill Sight and Hold this Level with SKY Line or TreePart Number Part Description If YOU Need Repair Service or PartsFor Repair SERVICE, Call this Toll Free Number

917.257632 specifications

The Sears 917.257632 is a versatile lawn tractor that has been designed to cater to homeowners looking for efficiency and ease in lawn care. This model stands out with its blend of features that make it an attractive option for anyone looking to maintain a well-manicured yard.

One of the main features of the Sears 917.257632 is its powerful engine. It is equipped with a reliable 19 horsepower engine, providing ample power to handle various tasks throughout the yard. Whether mowing the lawn, hauling materials, or towing attachments, this lawn tractor ensures consistent performance.

The tractor boasts a wide cutting deck, typically measuring around 42 inches, which allows for a broader mowing path and reduces the time spent cutting the grass. The cutting height is easily adjustable, giving users the flexibility to choose their preferred grass length, ensuring a professional-looking finish every time.

The 917.257632 features a hydrostatic transmission, offering smooth and seamless speed adjustments without the need for gear shifting. This technology enhances ease of use, allowing operators to focus on navigating the lawn rather than managing gears. The intuitive foot pedal provides effortless control, making it easier to maneuver around obstacles.

Comfort is another significant aspect of the Sears 917.257632. The tractor comes with a cushioned seat that offers ample support during longer mowing sessions, ensuring an enjoyable experience. The ergonomic steering wheel is designed for optimal handling and ease of navigation, allowing users to operate the lawn tractor with minimal fatigue.

Additionally, the Sears 917.257632 includes ample storage options, with a compartment located near the operator’s seat to store essential tools and supplies. The tractor is designed with durability in mind, featuring robust materials that withstand regular use and varied weather conditions.

Safety features are critical in this model, with mechanisms such as a blade brake that automatically stops the blades when the operator leaves the seat. This ensures peace of mind while operating the machine, particularly on uneven terrain.

In summary, the Sears 917.257632 is a well-rounded lawn tractor that combines power, comfort, and advanced technology, making it an excellent choice for homeowners seeking a reliable solution for their lawn care needs. Its diverse features and user-friendly design enhance the overall mowing experience, setting it apart in the competitive market of lawn tractors.
Top Page Image Contents