Cover
Spool
2.Remove any remaining line.
3.Clean dirt and debris from all parts. Re- place spool if it is worn or damaged.
4.Replace with a
WARNING: Never use wire, rope, string, etc., which can break off and become a dangerous missile.
5.When installing new line on an existing spool, hold the spool as shown.
6.Bend the line at the midpoint and insert the bend into the slot in the center rim of the spool. Ensure line snaps into position in the slot.
Slot
7.With your finger between the lines, wrap the lines evenly and firmly around the spool in a clockwise direction.
8.Position the lines in the guide slots. Guide slot
Guide slot
9.Place the spool in the cover as shown below.
10.Insert the ends of the lines through exit holes in the sides of the cover.
Line exit hole
Cover
11.Reinstall the spool and cover onto the trimmer head. Push until cover snaps into place.
17