McCulloch 115249726 instruction manual Storage, Blade Replacement, Carburetor Adjustment, Porting

Page 18

BLADE REPLACEMENT

Refer to the ASSEMBLY section for blade re- placement instructions and illustrations.

CARBURETOR ADJUSTMENT

WARNING: Keep others away when making idle speed adjustments. The trimmer head will be spinning during most of this pro- cedure. Wear your protective equipment and observe all safety precautions. After making adjustments, the trimmer head must not move/spin at idle speed.

The carburetor has been carefully set at the factory. Adjustments may be necessary if you notice any of the following conditions:

S Engine will not idle when the throttle is re- leased.

SThe trimmer head moves/spins at idle speed.

Make adjustments with the unit supported so the cutting attachment is off the ground and will not make contact with any object. Hold the unit by hand while running and making ad- justments. Keep all parts of your body away from the cutting attachment and muffler.

Idle Speed Adjustment

Allow engine to idle. Adjust speed until engine runs without trimmer head moving or spinning (idle speed too fast) or engine stalling (idle speed too slow).

S Turn idle speed screw clockwise to in- crease engine speed if engine stalls or dies.

STurn idle speed screw counterclockwise to decrease engine speed if trimmer head moves or spins at idle speed.

WARNING: Recheck the idle speed after each adjustment. The trimmer head must not move or spin at idle speed to avoid serious injury to the operator or others.

Idle speed screw

Air filter cover

If you require further assistance or are unsure about performing this procedure, contact an authorized service dealer.

STORAGE

WARNING: Perform the following steps after each use:

SAllow engine to cool before storing or trans-

porting.

SStore unit and fuel in a well ventilated area where fuel vapors cannot reach sparks or open flames from water heaters, electric motors or switches, furnaces, etc.

SEmpty fuel tank before storing or transport- ing the unit.

SStore unit and fuel well out of the reach of children.

SStore unit with all guards in place. Position unit so that any sharp object cannot acci- dentally cause injury.

18

Image 18
Contents Manuel D’INSTRUCTIONS BetriebsanweisungManual DE Instrucciones Table of Contents Identification What is WHAT?Identification of Symbols Safety RulesHazard Zone Operator SafetyUnit / Maintenance Safety Are doing use common senseAssembly Attaching the Handle Installing Trimmer AttachmentAssembly of Shoulder Strap To Relocate Shoulder Strap ClampConfiguring Your Unit Assembly Information Trimmer HeadAttaching the Plastic Shield and Trimmer Head Attaching the Metal Shield Assembly Information Weed BladeInstallation of the Metal Blade Wrench Nut Gearbox Dust cup Aligned holes Retaining washerFueling Engine OperationAttaching the Transport Guard GuardInstalling Optional ATTACH- Ments HOW to Stop Your UnitHOW to Start Your Unit Starting a Flooded EngineTrimmer Line Advance Operating PositionOperating Instructions for USE with Trimmer Head Cutting MethodsCm above ground Operating Instructions for USE with Weed BladeTrimming MowingAdditional Safety Rules Edger SafetyBLOWER/VACUUM Safety Pole Pruner Safety Cultivator SafetyHedge Trimmer Safety Attached Cm in diameter Snow Thrower Safety Speed when not pruning AnotherMaintenance Service and AdjustmentsCover Spool Remove any remaining line Engine will not idle when the throttle is re- leased Blade ReplacementCarburetor Adjustment StorageEngine Troubleshooting Table Cause RemedySeasonal Storage OtherDeclaration of Conformity EC Declaration of Conformity Only applies to Europe09--1--31 Technical Data Noise Levels Octave Band Analysis 100-10000hz 1/3 Octave