Woods Equipment RDC54, RD60, RD72 manual Attachment Points Tether Chain

Attach Mower to Tractor￿￿￿￿￿￿￿

„Make sure spring-activated locking pin or collar slides freely and is seated firmly in tractor PTO spline groove.

The standard 1-3/8" 6B-spline driveline with a QD yoke is used to connect the mower to the tractor.

1.Attach the mower hitch pins to the lower tractor lift arms and secure.

2.Attach tractor top link (1), Figure 2, to mower top link bracket attachment point (A). Connect the driveline to the tractor PTO shaft.

3.Attach tether chain to tractor drawbar (Figure 3).

4.Adjust the tractor lower 3-point arm anti-sway devices to prevent mower from swinging side to side during transport.

A	1
B
CD3944

1. Tractor Top Link

A.Mower Top Link Attachment Point

B.Mower Hitch Pin

Figure 2. Attachment Points

Tether Chain

CM906

Figure 3. Attach Mower to Tractor

Adjust Cutting Height￿￿￿￿￿￿￿

„Keep all persons away from operator control area while performing adjustments, service, or maintenance.

IMPORTANT

■Avoid low cutting heights. Striking the ground with blades produces one of the most damaging shock loads a mower can encounter. Allowing blades to contact ground repeatedly will cause damage to mower and drive.

1.Level mower from side to side. Check by measuring distance from mower frame to the ground at each deck rail.

2.Verify that the same amount of spacers are under all caster arms.

3.Control cutting height by adjusting front and rear caster wheels.

4.To raise rear of mower, move caster adjustment spacers under rear caster arms.

5.To raise front of mower, move spacers under front caster wheel arms.

Table 1: Cutting Height Chart

Spacers Required Under

Caster Arm Pivot Tube

Cut Height	1/2" Spacer	1" Spacer
1"	0	0
1-1/2"	1	0
2"	0	1
2-1/2"	1	1
3"	0	2
3-1/2"	1	2
4"	0	3
4-1/2"	1	3

MAN0260 (8/6/2004) Operation 9