Woods Equipment RDC54, RD60, RD72 manual Storage

Page 7

SAFETY RULES

ATTENTION! BECOME ALERT! YOUR SAFETY IS INVOLVED!

„Make certain all movement of equipment com- ponents has stopped before approaching for ser- vice.

„Never go underneath equipment (lowered to the ground or raised) unless it is properly blocked and secured. Never place any part of the body under- neath equipment or between moveable parts even when the engine has been turned off. Hydraulic system leak down, hydraulic system failures, mechanical failures, or movement of control levers can cause equipment to drop or rotate unexpect- edly and cause severe injury or death. Follow Oper- ator's Manual instructions for working underneath and blocking requirements or have work done by a qualified dealer.

„Frequently check blades. They should be sharp, free of nicks and cracks, and securely fastened.

„Do not handle blades with bare hands. Careless or improper handling may result in serious injury.

„Your dealer can supply genuine replacement blades. Substitute blades may not meet original equipment specifications and may be dangerous.

„Tighten all bolts, nuts, and screws to torque chart specifications. Check that all cotter pins are installed securely to ensure equipment is in a safe condition before putting unit into service.

„Make sure all safety decals are installed. Replace if damaged. (See Safety Decals section for location.)

„Make sure shields and guards are properly installed and in good condition. Replace if dam- aged.

„Wear gloves when installing belt. Be careful to prevent fingers from being caught between belt and pulley.

„Use care when installing or removing belt from spring-loaded idler. Springs store energy when extended and, if released suddenly, can cause per- sonal injury.

STORAGE

„Follow manual instructions for storage.

„Keep children and bystanders away from stor- age area.

™

RD 54/60/72 (Rev. 1/13/2006)

Safety 5

Image 7
Contents Heritage Rear Discharge Mower To the Dealer IntroductionLEA EL Instructivo Table of ContentsGeneral Information SpecificationsRD60 RD72 Preparation SafetySafety Rules TrainingTransportation MaintenanceStorage 1003751 Safety & Instructional DecalsBe Careful Replace Immediately If DamagedTractor Stability Respirator or filter mask where appropriateOperation OperationAttachment Points Tether Chain Operating Technique Tractor Top Link AdjustmentFront Caster Wheel Interference Check Front Roller OptionalMower Storage Position Removing Mower from Tractor StorageOwners Responsibility Owner PRE-OPERATION Check ListLubrication Information Owner ServiceOwner Service Blocking MethodDescription Frequency Driveshaft Lubrication Service BeltInstall Belt Service BladeChain Shielding Install BladesCleaning Sharpen BladesPeriodically or Before Extended Storage Mowing Conditions TroubleshootingBelt Conditions Trouble ShootingDisassemble Spindle Dealer ServiceBlade Spindle Repair Remove SpindleGearbox Repair Seal ReplacementSeal Installation Assemble SpindleSeal Installation Disassemble Gearbox Vertical Shaft Seal ReplacementHorizontal Shaft Seal Replacement Remove Gearbox from MowerAll Models Install GearboxInstall Drive Sheave RD60 & RD72Universal Joint Repair Joint DisassemblyJoint Assembly Dealer SET-UP Instructions AssemblyAssembly Instructions Install A-Frame ArmsInstall Chain Shielding Optional Install Rear Offset Link ArmsInstall Top Link Install DriveshaftX 4-3/4 Hhcs Install Quick Hitch Kit Optional RD60 & RD72 OnlyFront Roller Installation Install Front Roller OptionalDealer Delivery Check List Dealer Check ListsDealer Check Lists Dealer PRE-DELIVERY Check ListParts PartsMetric Series Bolt Torque ChartSAE Series Torque Chart AppendixAbbreviations Bolt Size ChartIndex IndexWarranty Rev /23/2005 MAN0260