Woods Equipment RDC54, RD60, RD72 manual Dealer Check Lists, Dealer PRE-DELIVERY Check List

DEALER CHECK LISTS

DEALER PRE-DELIVERY CHECK LIST

(DEALER’S RESPONSIBILITY)

Inspect the equipment thoroughly after assembly to		___	Check all bolts to be sure they are properly
ensure it is set up properly before delivering it to the			torqued.
customer.		___	Check that all cotter pins and safety pins are
The following check lists are a reminder of points to			properly installed. Replace if damaged.
inspect. Check off each item as it is found satisfactory		___	Check and grease all lubrication points as iden-
or after proper adjustment is made.
			tified in “lubrication information” on page 13.
___	Check that all safety decals are installed and in	___	Gearboxes are not filled at the factory. Prior to
	good condition. Replace if damaged.
			delivery, fill as specified in the "Service, lubrica-
___	Check that shields and guards are properly		tion information" on page 13 and check to see
	installed and in good condition. Replace if dam-		that there are no leaking seals.
	aged.	___	Check that blades have been properly installed.

DEALER DELIVERY CHECK LIST

(DEALER’S RESPONSIBILITY)

___ Show customer how to make adjustments and select proper PTO speed.

___ Instruct customer how to lubricate and explain importance of lubrication.

___ Point out the safety decals. Explain their mean- ing and the need to keep them in place and in good condition. Emphasize the increased safety hazards when instructions are not followed.

___ Present Operator's Manual and request that customer and all operators read it before oper- ating equipment. Point out the manual safety rules, explain their meanings and emphasize the increased safety hazards that exist when safety rules are not followed.

___ Show customer how to make sure driveline is properly installed and that spring-activated lock- ing pin or collar slides freely and is seated in groove on tractor PTO shaft.

___ Show customer the safe, proper procedures to be used when mounting, dismounting, and stor- ing equipment.

___ Explain to customer the potential crushing haz- ards of going underneath raised equipment. Instruct that before going underneath to discon- nect the driveline, securely block up all corners with jackstands and to follow all instructions in the "Service, blocking methods" section of the Operator’s Manual. Explain that blocking up prevents equipment dropping from hydraulic leak down, hydraulic system failures, or mechanical component failures.

___ For mounted units, add wheel weights, ballast in front tires, and/or front tractor weight to enhance front end stability. A minimum 20% of tractor and equipment gross weight must be on front tractor wheels. When adding weight to attain 20% of tractor and equipment weight on front tractor wheels, you must not exceed the ROPS weight certification. Weigh the tractor and equipment. Do not estimate!

___ Make customer aware of optional equipment available so that customer can make proper choices as required.

___ Point out all guards and shields. Explain their importance and the safety hazards that exist when not kept in place and in good condition.

MAN0260 (8/6/2004) Dealer Check Lists 31