Assembly, Dealer SET-UP Instructions | Woods Equipment L306A-3

ASSEMBLY

DEALER SET-UP INSTRUCTIONS

This mower is equipped with suction type blades for best results in lawn mowing.

A WARNING

Before working underneath, block mower securely. Hydraulic system leak down and failure of mechanical or hydraulic system can cause equip- ment to drop.

Keep all persons away from operator control area while performing adjustments, service or maintenance.

A CAUTION

Always wear relatively tight and belted cloth- ing to avoid entanglement in moving parts. Wear sturdy, rough-soled work shoes and protective equipment for eyes, hands, hearing and head.

The mower is shipped partially assembled. Assembly will be easier if components are aligned and loosely assembled before tightening hardware. Recommended torque values for hardware are located on page 45.

Optional equipment such as front roller, leaf mulcher or blades should be installed before mower is mounted on tractor. Casters are easier to install after mower is mounted on tractor. See the Optional Equipment sec- tion, page 26, for installation instructions.

Select a suitable working area to assemble mower. Open accompanying parts box and lay parts out to make location easy.

Side Skid Installation

Attach side skids to the outer rail with 3/8 x 1-1/4" bolts. Final alignment of skids will be necessary when cutting height is established.

Side Shield or

Discharge Chute Installation

A DANGER

Do not operate mower unless either dis- charge chute or side shield is installed.

Attach side shields to right and left side of the mower. The baffle shield fits the left side.

A side discharge chute may be used in place of the left side shield for mowing in heavy material. Mount the shields or discharge with 3/8 x 1" bolts and flange lock nuts.

1.Discharge Chute

2.Side Shield

3.Side Skid

Figure 10. Side Skid, Discharge Chute

& Side Shield Installation

Crosswise Support Installation

Attach crosswise support (1) to mower deck, welded lug forward. Insert spacer bushing (2) into hole, insert bolt through deck and slide support onto bolt. Secure with nut.

Center Belt Shield

See page 36. Assemble center belt shield bracket (21) to mower deck with a 3/8 NC x 1 hex head cap screw (31). Secure with 3/8 lock washer (32) and 3/8 NC hex nut (33). Attach center belt shield (22) to screws welded into mower deck just forward of center blade spindle sheave and secure with 3/8 lock washer (32) and 3/8 NC hex nut (33). Secure center belt shield to center belt shield bracket with 3/8 lock washer (32) and 3/8 NC hex nut (33).

15148 (Rev. 2/9/2007)	Assembly 19