Lift Chain Installation on Deck
Figure 13. Lift Chain Installation
(L306 Deck Shown)
Lift chains are inserted into keyhole brackets on mower deck and secured with caplugs.
On L59 mowers, there are two sets of keyhole brackets - front and rear. Attach lift chains in the front brackets.
On L306 mowers, there are two sets of three keyhole brackets. All mounts use the front outside brackets.
TRACTOR PREPARATION
Idler Bracket Installation
NOTICE
It may be necessary to cut off front corners of drawbar on older tractors to clear idler bracket push arms.
Locate idler bracket (4) up against inside gear housing
(6)and determine if any of the drawbar will need to be removed to ensure a good fit. Cut drawbar if necessary.
Install idler bracket (4) with 3/4" hardware as shown in Figure 14 and torque bolts to 300
NOTICE
On some older tractors, it may be necessary to substitute 5/8" hardware for the 3/4" hardware. The 5/8" hardware is not furnished with parts pack- age. If your wheel housing only has two holes in front, it will be sufficient. Frequently check that these bolts are tight to prevent idler bracket from moving. Torque 5/8" bolts to 175
If your tractor is equipped with a fast hitch, move hitch as far as possible to the right to prevent interference with belt and idlers.
1.3/4" Flat Washer
2.3/4" Lock Washer
3.3/4 x
4.Idler Bracket
5.Tractor Drawbar
6.Left Rear Planetary Gear Housing
Figure 14. Idler Bracket Installation
NOTICE
Proper installation is necessary to ensure proper belt alignment.
Insert carriage bolt (4), from the left, through front slot. Place three washers (5) on bolt and install pulley (1), lock washer (6) and nut (7).
Install carriage bolt (4) through rear slot, placing belt guide (2) on left side of idler slot. Then place three washers (5), pulley (1), lock washer (6) and nut (7) on bolt.
Do not tighten this hardware until belt is installed.
15148 (Rev. 2/9/2007) | Assembly 21 |
|
|