Woods Equipment RBC60 LRC60 manual Tail Wheel Adjustment LRC60 Optional, Cleaning, After Each Use

TAIL WHEEL ADJUSTMENT LRC60 (OPTIONAL)

1.Raise rake until tail wheels clear the ground.

2.To raise tail wheels, remove klik pin (10) and washer (17). Allow clevis and shaft (7) to slide down in tail wheel arm (9). Do not remove shaft completely from wheel arm.

3.Rotate height adjustment spacer(s) (8), align slot with groove at bottom of shaft, and remove spacer(s).

4.Slide clevis and shaft back into position; place removed spacer(s) over top of shaft.

5.Install klik pin and washer.

6.To lower gauge wheels, reverse the procedure.

NOTE: Use a good multi-purpose to grease pivot tube and caster wheel every 8 hours of operation.

	17
9
8
	CD6157-3
10
7
7.	Clevis
8.	1/2" Height adjustment spacer
9.	Tail wheel arm
10.	Klik pin, 1/4 x 1-3/4
17.	Washer, 1-1/6 x 1-9/16 x 10 ga

Figure 11. Caster Wheel Adjustment

CLEANING

After Each Use

●Remove large debris such as clumps of dirt, grass, crop residue, etc. from machine.

●Inspect machine and replace worn or damaged parts.

●Replace any safety decals that are missing or not readable.

Periodically or Before Extended Storage

●Clean large debris such as clumps of dirt, grass, crop residue, etc. from machine.

●Remove the remainder using a low-pressure water spray.

1.Be careful when spraying near scratched or torn safety decals or near edges of decals as water spray can peel decal off surface.

2.Be careful when spraying near chipped or scratched paint as water spray can lift paint.

3.If a pressure washer is used, follow the advice of the pressure washer manufacturer.

●Inspect machine and replace worn or damaged parts.

●Sand down scratches and the edges of areas of missing paint and coat with Woods spray paint of matching color (purchase from your Woods dealer).

●Replace any safety decals that are missing or not readable (supplied free by your Woods dealer). See Safety Decals section for location drawing.

14 Maintenance MAN0169 (Rev. 5/6/2005)