Woods Equipment FSW6000T, FSW6000F manual Operation

OPERATION

Safety is a primary concern in the design and manufacture of our products. Unfortunately, our efforts to provide safe equipment can be wiped out by an operator’s single careless act.

In addition to the design and configuration of equipment, hazard control and accident preven- tion are dependent upon the awareness, con- cern, judgement, and proper training of personnel involved in the operation, transport, maintenance, and storage of equipment.

It has been said, “The best safety device is an informed, careful operator.” We ask you to be that kind of operator.

A WARNING

„Safety instructions are important! Read all attachment and power unit manuals; follow all safety rules and safety decal information. (Replace- ment manuals and safety decals are available from your dealer. To locate your nearest dealer, check the Dealer Locator at www.WoodsEquipment.com, or in the United States and Canada call 1-800-319- 6637.) Failure to follow instructions or safety rules can result in serious injury or death.

„Make sure the driveline spring-activated locking collar slides freely and is seated firmly in power unit PTO groove. Make sure the set screws securely attach driveline to the attachment gearbox shaft.

„Before performing any service or maintenance, lower attachment to ground, turn off power unit engine, remove key, and disconnect battery ground cable (negative -).

„Make sure attachment is properly secured, adjusted, and in good operating condition.

„Never allow children or untrained persons to operate equipment.

„Keep bystanders away from equipment.

„Do not stop, start, or change directions sud- denly on slopes.

A CAUTION

„Always wear relatively tight and belted clothing to avoid getting caught in moving parts. Wear sturdy, rough-soled work shoes and protective equipment for eyes, hair, hands, hearing, and head; and respirator or filter mask where appropriate.

REAR TRACTOR WEIGHT

REQUIREMENTS

The sweeper attachment requires additional rear trac- tor weight as shown in the counterweight chart below.

Contact your WOODS dealer for counterweights and mount kit appropriate for your specific tractor.

REAR TRACTOR COUNTERWEIGHT

REQUIREMENT CHART

Sweeper	Mow’n Machines
Model	F-Series	F-Series with
		ROPS
60" Sweeper	100 lbs.	150 lbs.

2-WAY ANGLE MOUNT HEIGHT ADJUSTMENT

The sweeping height of the broom should be adjusted by the actuator motor. When using the broom for de- thatching, the gauge wheels should be mounted to the sides of the Sweeper broom and the height of the broom should be adjusted by placing spacers on the wheel forks above or below the fork housings.

FIXED ANGLE HEIGHT ADJUSTMENT

The sweeping height of the broom is adjusted by push- ing the button on the end of the adjustment lever and moving lever rearward to raise broom and forward to lower broom.

SWEEPING TIPS

A WARNING

„Never place any part of the body underneath implement/attachment or between its moving parts even when the engine has been turned off. Service work does not require going underneath unit. Mechanical failures, electrical failures, or operating controls can cause equipment to drop.

„Before performing any service or maintenance, lower attachment to ground, turn off power unit engine, remove key, and disconnect battery ground cable (negative -).

„Make sure shields and guards are properly installed and in good condition. Replace if damaged.

„Keep hands, feet, hair, and clothing away from equipment while engine is running. Stay clear of all moving parts.

Always operate tractor engine at full governed RPM when using the bi-directional broom for snow removal.

6 Operation MAN0118 (Rev. 12/23/2004)