HYDRAULIC INSTALLATION
Keep hands and body away from pressurized lines. Use paper or cardboard, not hands or other body parts to check for leaks. Wear safety gog- gles. Hydraulic fluid under pressure can easily penetrate skin and will cause serious injury or death.
Make sure that all operating and service per- sonnel know that if hydraulic fluid penetrates skin, it must be surgically removed as soon as possible by a doctor familiar with this form of injury or gangrene, serious injury, or death will result. CONTACT A PHYSICIAN IMMEDIATELY IF FLUID ENTERS SKIN OR EYES. DO NOT DELAY.
Make sure all hydraulic hoses, fittings, and valves are in good condition and not leaking before starting power unit or using equipment. Check and route hoses carefully to prevent dam- age. Hoses must not be twisted, bent sharply, kinked, frayed, pinched, or come into contact with any moving parts. Operate moveable components through full operational range to check clear- ances. Replace any damaged hoses immediately.
Install Hydraulic Fittings and Hoses
1.Attach bulkhead adapter (4), adapter (7) and male quick coupler (5) to bulkhead adapter bracket (13).
2.Attach bulkhead adapter bracket assembly to the inside of right rear fender using two cap screws (14), flat washers (15),and hex nuts (16).
3.Attach end of hose (2) to the back side of bulk- head adapter (4).
Continued on next page.
14 15
16
2
4
7
5
DP19
Figure 11. Bulkhead Adapter Bracket Installed
10 Installation | MAN0579 (1/19/2007) |
|
|