Install Hydraulic Fittings and Hoses (Continued)
4.Locate the hydraulic tee on the right side of the tractor and remove the hydraulic cap (Figure 12).
5.Route hose (2) over rear axle and connect oppo- site end of hose to hydraulic tee (Figure 13).
Remove
Hydraulic Cap
DP7
Figure 12. Remove Hydraulic Cap (Typical)
DP8
Figure 13. Hose Connection
2. 1021004 Hose, 45" x 3/4 JICF x 7/8 JICF 90°
4. 1006144 Adapter,
Bulkhead 3/8 NPTM x 3/4 JICM
5.26124 Quick coupler set, male & female 1/2
7.10802 Adapter, 3/8 NPTF x 1/2 NPTM
10.307126 M8 x 1.25P x 55 mm HHCS
11.4378 5/16 Flat washer
12.30515 M8 x 1.25P Hex nut
13.1021007 Bulkhead adapter bracket
14.10378 1/4 NC x 1 HHCS GR5
15.5336 1/4 Flat washer
16.5288 1/4 NC Hex nut
Figure 14. Hose assembly
MAN0579 (1/19/2007) | Installation 11 |
|
|