Woods Equipment 1023000 installation manual Connect Hydraulic Hoses, Attach 3-Point Arms

Page 16

STORAGE

Connect Hydraulic Hoses

TRACTOR: Disconnect hydraulic hoses from between backhoe and tractor.

BACKHOE: Connect hoses together to prevent dirt from accumulating in quick couplers.

-OR-

Remove hydraulic pump from the PTO shaft if equipped. Store pump on backhoe platform to prevent dirt and debris from accumulating in pump adapter.

Attach 3-Point Arms

The lower 3-point lift arms and anti-sway links can be used on tractor when backhoe is removed.

Attach 3-point lift arms anti-sway links to tractor brackets as shown in Figure 19. Secure using clevis pin (26) and safety pin previously removed with 3- point arms.

26. 62540 Clevis pin, .75 x 2.76

26

DP8

DP9

Figure 19. Right Anti-Sway Link Attached to Tractor Bracket

16 Installation	MAN0579 (1/19/2007)

Image 16

Contents MAN0579 Introduction To the DealerSafety Safety RulesSafety Rules from previous Installation Tractor PreparationInstall Cylinder Brackets Install Right and Left Top BracketsInstall Right and Left Tractor Brackets Right Tractor Bracket Installed, BottomInstall Crossmember Torque Mounting HardwareBackhoe Bracket Installation Attach Backhoe Brackets to BackhoeInstall Hydraulic Fittings and Hoses Bulkhead Adapter Bracket InstalledRemove Hydraulic Cap Typical Install Backhoe Valve Hoses Backhoe to Tractor Hose ConnectionHydraulic System Check List Mount Backhoe to TractorMount Backhoe Refer to Figure Remove Backhoe from Tractor Backhoe Storage PositionConnect Hydraulic Hoses Attach 3-Point ArmsInstallation Parts 1023000 4-POINT SUB-FRAME Mounting KIT1023000 4-POINT SUB-FRAME Mounting KIT Parts List Part QTY DescriptionHose KIT Bolt Torque Chart AppendixBolt Size Chart AbbreviationsWarranty Warranty