Remove Backhoe from Tractor
The only time the backhoe may be operated
from a position other than the operator seat is during backhoe attachmentand removal. Opera- tor must:
•Read Mounting Kit Manual instructions on attaching and removing backhoe and use extreme care.
•Always stand between rear tire and backhoe stabilizer arms or along side of tractor to avoid being trapped should the boom swing control be accidentally activated.
Remove seat and upper support assembly before installing or removing backhoe from power unit. Failure to comply may result in equipment failure and/or personal injury.
1.Position tractor on a hard, level surface and cen- ter the backhoe boom.
2.Lower stabilizers and take backhoe weight off tractor.
3.Lower boom and dipper to form
4.Remove the seat assembly.
5.Remove klik pins from bolt and nut assemblies.
6.Use
7.Use the boom to relieve excess pressure on 1- inch bolts and remove bolts.
8.Tilt backhoe main frame to separate slots on the backhoe brackets from the tractor brackets.
9.Raise stabilizers until backhoe brackets slide out of hooks on the bottom of the tractor brackets.
10.Move tractor forward to clear backhoe brackets.
11.Lower backhoe until backhoe main frame is firmly on the ground. Retract boom and dipper and place bucket cutting edge flat on the ground. See Figure 18. Connect transport lock and insert swing lock pin.
12.It may be necessary to place backhoe main frame on 6" blocks if backhoe hose lengths are not long enough to achieve proper clearance when separating backhoe from tractor.
13.Turn off engine, set brakes, and remove key.
14.Disconnect backhoe hydraulic system. See “STORAGE” on page 16.
13.Reinstall seat assembly.
NOTE: For instructions on extended storage, see backhoe operator’s manual.
Figure 18. Backhoe Storage Position
MAN0579 (1/19/2007) | Installation 15 |
|
|