Woods Equipment LF138, LF156 manual Grapple Installation Optional, Grease Loader

		Grapple Installation (Optional)
		1.	With the bucket attached to the loader, roll bucket
			forward until the back of it is parallel with the
			ground.
		2.	Secure right (2) and left (3) grapple attachment
			brackets to back of bucket using four (two per
			bracket) pins (15) and klik pins (23).
		3.	Place grapple grill (6) between attachment
			brackets and secure to lug on bucket with cap
		4.	screws (28) and nuts (29).
			Secure grapple grill (6) to right and left attachment
			bracket using cap screws (28) and nuts(29).
		5.	Attach grapple arm (4) to right attachment bracket
			using pin (18), cap screw (26) and lock nut (27).
		6.	Secure base end of cylinder to attaching bracket
			using pin (17), cap screw (26) and lock nut (27).
	Figure 40. Bucket Level Indicator Installed	7.	Repeat steps to secure second grapple arm (4)
Grease Loader			and cylinder to left attachment bracket.
Lubricate all pivot points shown on page 22 with a high		8.	Roll bucket back until front pads of grapple arms
			(4) are level with the ground.
quality SAE multi-purpose grease.
		9.	Place grapple toothbar (5) under grapple arms and
			secure using eight (four per arm) cap screws (25),
			sixteen hardened flat washers (21) and lock nuts
			(20).
			2.	Attachment bracket - right
			3.	Attachment bracket - left
			4.	Grapple arm
			5.	Grapple toothbar
			6.	Grapple grill
			15.	Hitch pin, 1.25 x 4.63
			17.	Pin, 1.25 x 5.50
			18.	Pin, 1.25 x 6.68
			20.	5/8 NC Lock nut
			21.	5/8 Hardened flat washer
			23.	Klik pin, 7/16 x 2
			25.	5/8 NC x 2-1/2 HHCS GR8
			26.	5/16 NC x 2-1/4 HHCS GR5
			27.	5/16 NC Lock nut
			28.	1/2 NC x 1-1/2 HHCS
			29.	1/2 NC nut

Figure 41. Grapple Assembly

(Rev. 1/6/2011) MAN0556 (9/21/2007)

Assembly 33