Stow G-4.5R manual Operation and Safety Decals S/N 5498030 and below, Machine Safety Decals

Page 14

OPERATION AND SAFETY DECALS (S/N 5498030 AND BELOW)

Machine Safety Decals

The G-4.5R portable generator is equipped with a number of safety decals (Figures 2A and 2B). These decals are provided for operator safety and maintenance information.The illustration below shows these decals as they appear on the machine.Should any of these decals become unreadable, replacements can be obtained from your dealer.

S-4984

DANGEROUS

GAS

WARNING

Only operate machine in well ventilated areas.

DO NOT inhale exhaust gases.

Only qualified personnel should install, use or service this equipment.

P/N A3562000003

FUEL COCK

 

 

 

 

 

 

 

 

ON

 

MODEL

 

 

 

 

 

 

SERIAL NO.

 

 

 

 

ON

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

CONTACT

 

 

 

 

 

 

S-3704

STOW PARTS DEPT.

 

 

 

 

 

P/N 8700611804

 

DANGER

 

Do not touch output terminals or

 

internal wiring while unit is operating.

S-4985

Turn off power before servicing.

DANGEROUS

Only qualified personnel should

install, use or service this

GAS

equipment.

P/N 8700611904

CAUTION

P/N 1980680004

S-1123

P/N 0800628504

CAUTION!

READ OWNER’S SERVICE MANUAL BEFORE OPERATING OR SERVICING THIS MACHINE.

ALWAYS KEEP UNAUTHORIZED, INEXPERIENCED, UNTRAINED PEOPLE AWAY FROM THIS MACHINE.

MAKE SURE ALL SAFETY DEVICES ARE OPERNATIONAL BEFORE THIS MACHINE IS STARTED. MAKE SURE ENGINE IS TURNED OFF AND SPARK PLUG WIRE DISCONNECTED BEFORE SERVICING THE MACHINE OR COMING IN CONTACT WITH ANY MOVING PART. IF EQUIPMENT IS POWERED BY AN ELECTRIC MOTOR, DISCONNECT ELECTRICAL PLUG.

NEVER LEAVE MACHINE UNATTENDED WHEN OPERATING ALWAYS STOP ENGINE AND ALLOW ENGINE TO COOL BEFORE ADDING FUEL OR OIL.

DCS01

OPERATE AT

3600 RPM ONLY

(FULL THROTTLE)

DAMAGE MAY RESULT IF

OPERATED AT LOWER SPEEDS

P/N 7900636004

WARNING!

Before connecting this generator to any building’s electrical system, a licensed electrician must install an isolation (transfer) switch.

Serious injury or death may result without this transfer switch.

P/N 0820610404

P/N 0820610304

OPERATING INSTRUCTIONS

1.Before starting check the oil and fuel level.

2.Switch the circuit breaker to the “OFF” position.

3.Open the fuel valve.

4.Pull the choke knob.

5.Turn the operation switch to the "RUN" position and push.

6.Pull the recoil starter.

7.After the engine starts, gradually push in the choke valve.

8.Run the generator for 3-5 minutes without load.

9.Check for any abnormal noise or smell.

10.Switch the circuit breaker to the “ON” position.

11.When stopping, remove the load and allow it to continue to run for 2-3 minutes before stopping engine.

12.Turn the operation switch to the "STOP" position.

13.After the engine completely stops. Close the fuel valve.

S-4607

P/N 7900638204

RUN

STOP

IDLE

G-4.5RCONTROL OPERATION SWITCH

 

 

120V

 

 

 

240/120V

AC VOLTMETER

AC CIRCUIT

FULL POWER

 

 

BREAKER

SWITCH

 

P/N A3512100502

OIL

ALARM

240V

GFCI120V

GROUND

Figure 2A. Operation and Safety Decals (S/N 5498030 and Below)

PAGE 14 — STOW G-4.5R A.C. GENERATOR— OPERATION & PARTS MANUAL — REV. #3 (03/13/06)

Page 13 Page 15
Image 14
Page 13 Page 15
Contents Model G-4.5R Page Heres HOW to GET Help Table of Contents Parts Ordering Procedures When ordering parts Please supply the following informationStow G-4.5R Dimensions DimensionsSpecifications Effects of Altitude and HeatRespiratory Hazards Stow G-4.5R Safety Message Alert SymbolsBurn Hazards Equipment Damage Rotating Parts HazardsStow G-4.5R Rules for Safe Operation Read this manualPower Cord Safety Stow G-4.5R Rules for Safe OperationDeath EmergenciesPage Operation and Safety Decals S/N 5498030 and below Machine Safety DecalsOperation and Safety Decals S/N 5498031 and Above Excitation System Stow G-4.5R FamilarizationControl Panel EngineIncandescent Loads Single Phase LoadStow G-4.5R Load Application Small MotorsStow G-4.5R Controls and Indicators Generator Controls and ComponentsStow G-4.5R Controls and Indicators Stow G-4.5R Controls and Indicators With S/N 5498031 and above Stow G-4.5R Generator Refueling Generator RefuelingIndoor Installation Stow G-4.5R InstallationOutdoor Installation MountingStow G-4.5R Installation Connecting the GroundMain Circuit Breaker General Inspection Prior to Operation Ground Power ToolsExtension Cable Engine Oil Check Stow G-4.5R PRE-INSPECTION EngineBefore Starting Fuel CheckStow G-4.5R Initial START-UP Engine Before Starting the EngineStow G-4.5R Initial START-UP ENGINE/OPERATION Noises that would associate with lose componentsMain Circuit Breaker on Stopping The Engine 120 VAC ReceptaclesStow G-4.5R Preparation for Long -TERM Storage Generator StoragePage Stow G-4.5R Maintenance Engine Engine Maintenance ScheduleMaintenance Stow G-4.5R Maintenance EngineCleaning the Fuel Strainer Stow G-4.5R Wiring Diagram S/N 5498030 and below Generator/Engine Wiring Diagram S/N 5498030 and BelowStow G-4.5R Wiring Diagram S/N 5498031 and Above Stow G-4.5R -TROUBLESHOOTING Engine Stow G-4.5R -TROUBLESHOOTING Engine WhiteStow G-4.5R -TROUBLESHOOTING Generator Generator TroubleshootingPage How to read the marks and remarks used in this parts book Items Found In the Items Number ColumnStow G-4.5R Suggested Spare Parts To 3 UnitsStow G-4.5R Name Plate and Decals S/N 5498030 and below Nameplate and Decals S/N 5498030 and belowStow G-4.5R Name Plate and Decals S/N 5498030 and below Stow G-4.5R Name Plate and Decals S/N 5498030 and Above Nameplate and Decals S/N 5498031 and AboveDecal Operating Instructions Decal StowDecalwarning Read Manual Stow G-4.5R Generator Assy Generator AssySET WASHER, Bearing Field Coil AssySET BOLT, Rotor Spring WasherStow G-4.5R Control BOX ASSY. S/N 549830 and below Control BOX ASSY. S/N 549830 and belowStow G-4.5R Control BOX ASSY. S/N 549830 and below Stow G-4.5R Control BOX ASSY. S/N 549831 and Above Control BOX ASSY. S/N 549831 and AboveVR1H102MHA Stow G-4.5R Control BOX ASSY. S/N 549831 and AboveHEX NUT Stow G-4.5R Pipe Frame ASSY. S/N 549830 and below Pipe Frame ASSY. S/N 549830 and belowEngine Base Pipe FrameSUPPORT, Pipe Frame Rubber SuspensionStow G-4.5R Pipe Frame ASSY. S/N 549831 and Above Pipe Frame ASSY. S/N 549830 and AboveHEX Head Bolt HangerPlastic Washer WASHER, FlatRobin EX270D20110- Crankcase Assy Crankcase AssyOIL Seal Valve GuideStem Seal Ball BearingRobin EX270D20110 Crankshaft and Piston Assy Crankshaft and Piston AssyFlange NUT Connecting ROD BoltCrankshaft CP Woodruff KEYRobin EX270D20110 Governor Assy Governor AssyGovernor Lever SPRING, AdjustGovernor Operation Assy Governor ShaftRobin EX270D20110 Intake and Exhaust Assy Intake and Exhaust AssySpring PIN, 4DX7.5DX11L Adjust SCREW, M5X0.5X23LPIN, CAMSHAFT, 9DX78.5L Release LeverRobin EX270D20110 AIR Cleaner Assy AIR Cleaner AssyElement Assy Body CPCOVER, LOW Profile Robin EX270D20110 Cooling Starting Assy Cooling Starting AssyBaffle 1, Case CP Blower Housing CP, YellowLABEL, Trademark 64D Baffle 2, HeadRobin EX270D20110 Carburetor Assy Fuel Lubricant AssyValve Choke Screw AdjustingValve Throttle JET SlowRobin EX270D20110 Flywheel Assy Flywheel AssyFlywheel CP Wire 2 CP, W/OIL SensorSwitch Assy Ignition Coil CPRobin EX270D20110 Electric Device Assy Electric Device AssyTapping Bolt OIL Sensor CPFLOAT, C/U CP3 Clamp CPTerms and Conditions of Sale Stow Construction Equipment Page Heres HOW to GET Help

G-4.5R specifications

The Stow G-4.5R is an exceptional piece of rugged engineering designed for professionals who require efficiency and reliability in demanding environments. This cutting-edge equipment stands out for its unique combination of robust features and innovative technologies.

At the heart of the G-4.5R is its powerful engine, designed to facilitate high-performance operations. The machine is equipped with a fuel-efficient powertrain that not only maximizes output but also minimizes consumption. This feature is crucial for users who need to operate over extended periods without frequent refueling, making the G-4.5R highly suitable for long-term projects.

The G-4.5R boasts an advanced hydraulic system that enhances its lifting capabilities. With optimized hydraulic mechanics, the machine can handle heavier loads with improved precision and speed. This ensures that users can perform tasks more efficiently, reducing downtime and increasing productivity. Furthermore, the hydraulic system is complemented by a robust frame, designed to withstand rigorous field conditions while providing stability during operation.

Another notable aspect of the Stow G-4.5R is its user-centric design. The operational interface is intuitively laid out, allowing users to easily navigate controls and features without extensive training. The ergonomic design of the operating cabin further enhances comfort, reducing fatigue during long working hours. Noise reduction technologies have also been integrated into the design, making the working environment more pleasant.

In terms of technology, the G-4.5R features real-time monitoring systems that provide crucial operational data. These systems allow users to track fuel levels, hydraulic pressures, and performance metrics at a glance. Such capabilities not only promote efficient resource management but also facilitate preventive maintenance, helping to prolong the machine’s lifespan.

Safety is paramount in the design of the G-4.5R, with multiple safety mechanisms in place. These include automatic shutdown features in case of system overloads, reinforced caging to protect operators, and enhanced visibility systems that ensure a clear line of sight during operation.

In summary, the Stow G-4.5R is a versatile, powerful, and user-friendly machine specifically designed for challenging work environments. With its combination of advanced technologies, ergonomic design, and safety features, the G-4.5R stands out as a top choice for professionals aiming for efficiency and reliability in their operations.
Top Page Image Contents