Stow manual Stow G-4.5R Initial START-UP Engine, Before Starting the Engine

Page 27

STOW G-4.5R — INITIAL START-UP (ENGINE)

CAUTION

DO NOT attempt to operate this generator until the Safety, General Information and Inspection sections of this manual have been read and thoroughly understood.

DO NOT attempt to operate this

generator until the Safety, General Information and Inspection sections of this manual have been read and thoroughly understood.

This section is intended to assist the operator with the initial start-upof the trash generator. It is extremely important that this section be read carefully before attempting to use the generator in the field.

Before Starting the Engine

1.Be sure to disconnect all electrical loads from the generator prior to starting the engine.

2.NEVER start the engine with the main circuit breaker in the “ON" position. Place the main circuit breaker (Figure 10) in the OFF position.

Figure 10. Main Breaker (OFF Position) Starting the Engine

1.Place the engine fuel valve lever (Figure 11) to the "ON" position.”

2.Placethechokelever (Figure12)inthe"CLOSED"position if starting a cold engine.

Figure 12. Choke Lever

3.Place the choke lever (Figure 12) in the "OPEN " position if starting a warm engine or the temperature is warm.

4.Place the operation switch (Figure 13) in the "RUN " position.

Figure 13. Operation Switch (RUN)

5.Grasp the starter grip (Figure 14) and slowly pull it out.The resistance becomes the hardest at a certain position, corre- spondingtothecompressionpoint.Pullthestartergripbriskly and smoothly for starting.

Figure 14. Starter Grip

Figure 11. Engine Fuel Valve Lever (ON Position)

CAUTION

DO NOT pull the starter rope all the way to the end.

DO NOT release the starter knob after pulling. Allow it to rewind as soon as possible.

STOW G-4.5R A.C. GENERATOR — OPERATION & PARTS MANUAL — REV. #3 (03/13/06) — PAGE 27

Page 26 Page 28
Image 27
Page 26 Page 28
Contents Model G-4.5R Page Heres HOW to GET Help Table of Contents When ordering parts Please supply the following information Parts Ordering ProceduresDimensions Stow G-4.5R DimensionsEffects of Altitude and Heat SpecificationsStow G-4.5R Safety Message Alert Symbols Burn HazardsRespiratory Hazards Rotating Parts Hazards Equipment DamageRead this manual Stow G-4.5R Rules for Safe OperationStow G-4.5R Rules for Safe Operation Power Cord SafetyEmergencies DeathPage Machine Safety Decals Operation and Safety Decals S/N 5498030 and belowOperation and Safety Decals S/N 5498031 and Above Engine Stow G-4.5R FamilarizationControl Panel Excitation SystemSmall Motors Single Phase LoadStow G-4.5R Load Application Incandescent LoadsGenerator Controls and Components Stow G-4.5R Controls and IndicatorsStow G-4.5R Controls and Indicators Stow G-4.5R Controls and Indicators With S/N 5498031 and above Generator Refueling Stow G-4.5R Generator RefuelingMounting Stow G-4.5R InstallationOutdoor Installation Indoor InstallationConnecting the Ground Stow G-4.5R InstallationGeneral Inspection Prior to Operation Ground Power Tools Extension CableMain Circuit Breaker Fuel Check Stow G-4.5R PRE-INSPECTION EngineBefore Starting Engine Oil CheckBefore Starting the Engine Stow G-4.5R Initial START-UP EngineNoises that would associate with lose components Stow G-4.5R Initial START-UP ENGINE/OPERATION120 VAC Receptacles Main Circuit Breaker on Stopping The EngineGenerator Storage Stow G-4.5R Preparation for Long -TERM StoragePage Engine Maintenance Schedule Stow G-4.5R Maintenance EngineStow G-4.5R Maintenance Engine Cleaning the Fuel StrainerMaintenance Generator/Engine Wiring Diagram S/N 5498030 and Below Stow G-4.5R Wiring Diagram S/N 5498030 and belowStow G-4.5R Wiring Diagram S/N 5498031 and Above Stow G-4.5R -TROUBLESHOOTING Engine White Stow G-4.5R -TROUBLESHOOTING EngineGenerator Troubleshooting Stow G-4.5R -TROUBLESHOOTING GeneratorPage Items Found In the Items Number Column How to read the marks and remarks used in this parts bookTo 3 Units Stow G-4.5R Suggested Spare PartsNameplate and Decals S/N 5498030 and below Stow G-4.5R Name Plate and Decals S/N 5498030 and belowStow G-4.5R Name Plate and Decals S/N 5498030 and below Nameplate and Decals S/N 5498031 and Above Stow G-4.5R Name Plate and Decals S/N 5498030 and AboveDecal Stow Decalwarning Read ManualDecal Operating Instructions Generator Assy Stow G-4.5R Generator AssySpring Washer Field Coil AssySET BOLT, Rotor SET WASHER, BearingControl BOX ASSY. S/N 549830 and below Stow G-4.5R Control BOX ASSY. S/N 549830 and belowStow G-4.5R Control BOX ASSY. S/N 549830 and below Control BOX ASSY. S/N 549831 and Above Stow G-4.5R Control BOX ASSY. S/N 549831 and AboveStow G-4.5R Control BOX ASSY. S/N 549831 and Above HEX NUTVR1H102MHA Pipe Frame ASSY. S/N 549830 and below Stow G-4.5R Pipe Frame ASSY. S/N 549830 and belowRubber Suspension Pipe FrameSUPPORT, Pipe Frame Engine BasePipe Frame ASSY. S/N 549830 and Above Stow G-4.5R Pipe Frame ASSY. S/N 549831 and AboveWASHER, Flat HangerPlastic Washer HEX Head BoltCrankcase Assy Robin EX270D20110- Crankcase AssyBall Bearing Valve GuideStem Seal OIL SealCrankshaft and Piston Assy Robin EX270D20110 Crankshaft and Piston AssyWoodruff KEY Connecting ROD BoltCrankshaft CP Flange NUTGovernor Assy Robin EX270D20110 Governor AssyGovernor Shaft SPRING, AdjustGovernor Operation Assy Governor LeverIntake and Exhaust Assy Robin EX270D20110 Intake and Exhaust AssyRelease Lever Adjust SCREW, M5X0.5X23LPIN, CAMSHAFT, 9DX78.5L Spring PIN, 4DX7.5DX11LAIR Cleaner Assy Robin EX270D20110 AIR Cleaner AssyBody CP COVER, LOW ProfileElement Assy Cooling Starting Assy Robin EX270D20110 Cooling Starting AssyBaffle 2, Head Blower Housing CP, YellowLABEL, Trademark 64D Baffle 1, Case CPFuel Lubricant Assy Robin EX270D20110 Carburetor AssyJET Slow Screw AdjustingValve Throttle Valve ChokeFlywheel Assy Robin EX270D20110 Flywheel AssyIgnition Coil CP Wire 2 CP, W/OIL SensorSwitch Assy Flywheel CPElectric Device Assy Robin EX270D20110 Electric Device AssyClamp CP OIL Sensor CPFLOAT, C/U CP3 Tapping BoltTerms and Conditions of Sale Stow Construction Equipment Page Heres HOW to GET Help

G-4.5R specifications

The Stow G-4.5R is an exceptional piece of rugged engineering designed for professionals who require efficiency and reliability in demanding environments. This cutting-edge equipment stands out for its unique combination of robust features and innovative technologies.

At the heart of the G-4.5R is its powerful engine, designed to facilitate high-performance operations. The machine is equipped with a fuel-efficient powertrain that not only maximizes output but also minimizes consumption. This feature is crucial for users who need to operate over extended periods without frequent refueling, making the G-4.5R highly suitable for long-term projects.

The G-4.5R boasts an advanced hydraulic system that enhances its lifting capabilities. With optimized hydraulic mechanics, the machine can handle heavier loads with improved precision and speed. This ensures that users can perform tasks more efficiently, reducing downtime and increasing productivity. Furthermore, the hydraulic system is complemented by a robust frame, designed to withstand rigorous field conditions while providing stability during operation.

Another notable aspect of the Stow G-4.5R is its user-centric design. The operational interface is intuitively laid out, allowing users to easily navigate controls and features without extensive training. The ergonomic design of the operating cabin further enhances comfort, reducing fatigue during long working hours. Noise reduction technologies have also been integrated into the design, making the working environment more pleasant.

In terms of technology, the G-4.5R features real-time monitoring systems that provide crucial operational data. These systems allow users to track fuel levels, hydraulic pressures, and performance metrics at a glance. Such capabilities not only promote efficient resource management but also facilitate preventive maintenance, helping to prolong the machine’s lifespan.

Safety is paramount in the design of the G-4.5R, with multiple safety mechanisms in place. These include automatic shutdown features in case of system overloads, reinforced caging to protect operators, and enhanced visibility systems that ensure a clear line of sight during operation.

In summary, the Stow G-4.5R is a versatile, powerful, and user-friendly machine specifically designed for challenging work environments. With its combination of advanced technologies, ergonomic design, and safety features, the G-4.5R stands out as a top choice for professionals aiming for efficiency and reliability in their operations.
Top Page Image Contents