Stow G-4.5R manual Main Circuit Breaker on Stopping The Engine, VAC Receptacles

Page 29

STOW G-4.5R — INITIAL START-UP ENGINE/OPERATION

13.Refer to the AC voltmeter (Figure 20) on the control box. The voltage indicated on the voltmeter should be 240 VAC with no load applied. If desired, verify with a voltmeter that 240V is present at the NEMA L6-20R (S/N 5498030 and below) and the NEMA L14-20R (S/N 5498031 and above) twist-lock receptacles. In addition verify that 120 VAC is present at all other twist-lock receptacles on either unit.

3.Place the main circuit breaker (Figure 22) in the ON position.

Figure 22. Main Circuit Breaker (ON)

Stopping The Engine

Normal Shutdown

1.Place the main circuit breaker (Figure 11) in the OFF position.

2.Remove the load from the generator, and let the engine run at idle for 3-5 minutes with the idle control switch in the ON position (Up)

3.Place the operation switch (Figure 23) in the STOP position.

Figure 20. 240/120 VAC Receptacles

When the full power switch is

NOTE in the 240V (down) position, up to half of the rated power of the

generator is available at the 120V duplex receptacle or any twist-lock receptacle on either

unit; or full rated power can be obtained at the 240V receptacle. Rembmber, when using a combination of dual receptacles, total load should not exceed the rated capacity of the generator.

Connecting the Load

1.Connect the load to the desired voltage output receptacle.

2.Place the idle control switch (Figure 21) in the ON position (Up).

Figure 23. Operation Switch (Stop)

4.Place the engine fuel valve lever (Figure 24) to the "OFF" position.”

Figure 24. Engine Fuel Valve Lever (OFF Position)

Emergency Showdown

1.Place the operation switch (Figure 23) in the STOP position.

Figure 21. Idle Control Switch (Up)

STOW G-4.5R A.C. GENERATOR — OPERATION & PARTS MANUAL — REV. #3 (03/13/06) — PAGE 29

Page 28 Page 30
Image 29
Page 28 Page 30
Contents Model G-4.5R Page Heres HOW to GET Help Table of Contents When ordering parts Please supply the following information Parts Ordering ProceduresDimensions Stow G-4.5R DimensionsEffects of Altitude and Heat SpecificationsRespiratory Hazards Stow G-4.5R Safety Message Alert SymbolsBurn Hazards Rotating Parts Hazards Equipment DamageRead this manual Stow G-4.5R Rules for Safe OperationStow G-4.5R Rules for Safe Operation Power Cord SafetyEmergencies DeathPage Machine Safety Decals Operation and Safety Decals S/N 5498030 and belowOperation and Safety Decals S/N 5498031 and Above Control Panel Stow G-4.5R FamilarizationExcitation System EngineStow G-4.5R Load Application Single Phase LoadIncandescent Loads Small MotorsGenerator Controls and Components Stow G-4.5R Controls and IndicatorsStow G-4.5R Controls and Indicators Stow G-4.5R Controls and Indicators With S/N 5498031 and above Generator Refueling Stow G-4.5R Generator RefuelingOutdoor Installation Stow G-4.5R InstallationIndoor Installation MountingConnecting the Ground Stow G-4.5R InstallationMain Circuit Breaker General Inspection Prior to Operation Ground Power ToolsExtension Cable Before Starting Stow G-4.5R PRE-INSPECTION EngineEngine Oil Check Fuel CheckBefore Starting the Engine Stow G-4.5R Initial START-UP EngineNoises that would associate with lose components Stow G-4.5R Initial START-UP ENGINE/OPERATION120 VAC Receptacles Main Circuit Breaker on Stopping The EngineGenerator Storage Stow G-4.5R Preparation for Long -TERM StoragePage Engine Maintenance Schedule Stow G-4.5R Maintenance EngineMaintenance Stow G-4.5R Maintenance EngineCleaning the Fuel Strainer Generator/Engine Wiring Diagram S/N 5498030 and Below Stow G-4.5R Wiring Diagram S/N 5498030 and belowStow G-4.5R Wiring Diagram S/N 5498031 and Above Stow G-4.5R -TROUBLESHOOTING Engine White Stow G-4.5R -TROUBLESHOOTING EngineGenerator Troubleshooting Stow G-4.5R -TROUBLESHOOTING GeneratorPage Items Found In the Items Number Column How to read the marks and remarks used in this parts bookTo 3 Units Stow G-4.5R Suggested Spare PartsNameplate and Decals S/N 5498030 and below Stow G-4.5R Name Plate and Decals S/N 5498030 and belowStow G-4.5R Name Plate and Decals S/N 5498030 and below Nameplate and Decals S/N 5498031 and Above Stow G-4.5R Name Plate and Decals S/N 5498030 and AboveDecal Operating Instructions Decal StowDecalwarning Read Manual Generator Assy Stow G-4.5R Generator AssySET BOLT, Rotor Field Coil AssySET WASHER, Bearing Spring WasherControl BOX ASSY. S/N 549830 and below Stow G-4.5R Control BOX ASSY. S/N 549830 and belowStow G-4.5R Control BOX ASSY. S/N 549830 and below Control BOX ASSY. S/N 549831 and Above Stow G-4.5R Control BOX ASSY. S/N 549831 and AboveVR1H102MHA Stow G-4.5R Control BOX ASSY. S/N 549831 and AboveHEX NUT Pipe Frame ASSY. S/N 549830 and below Stow G-4.5R Pipe Frame ASSY. S/N 549830 and belowSUPPORT, Pipe Frame Pipe FrameEngine Base Rubber SuspensionPipe Frame ASSY. S/N 549830 and Above Stow G-4.5R Pipe Frame ASSY. S/N 549831 and AbovePlastic Washer HangerHEX Head Bolt WASHER, FlatCrankcase Assy Robin EX270D20110- Crankcase AssyStem Seal Valve GuideOIL Seal Ball BearingCrankshaft and Piston Assy Robin EX270D20110 Crankshaft and Piston AssyCrankshaft CP Connecting ROD BoltFlange NUT Woodruff KEYGovernor Assy Robin EX270D20110 Governor AssyGovernor Operation Assy SPRING, AdjustGovernor Lever Governor ShaftIntake and Exhaust Assy Robin EX270D20110 Intake and Exhaust AssyPIN, CAMSHAFT, 9DX78.5L Adjust SCREW, M5X0.5X23LSpring PIN, 4DX7.5DX11L Release LeverAIR Cleaner Assy Robin EX270D20110 AIR Cleaner AssyElement Assy Body CPCOVER, LOW Profile Cooling Starting Assy Robin EX270D20110 Cooling Starting AssyLABEL, Trademark 64D Blower Housing CP, YellowBaffle 1, Case CP Baffle 2, HeadFuel Lubricant Assy Robin EX270D20110 Carburetor AssyValve Throttle Screw AdjustingValve Choke JET SlowFlywheel Assy Robin EX270D20110 Flywheel AssySwitch Assy Wire 2 CP, W/OIL SensorFlywheel CP Ignition Coil CPElectric Device Assy Robin EX270D20110 Electric Device AssyFLOAT, C/U CP3 OIL Sensor CPTapping Bolt Clamp CPTerms and Conditions of Sale Stow Construction Equipment Page Heres HOW to GET Help

G-4.5R specifications

The Stow G-4.5R is an exceptional piece of rugged engineering designed for professionals who require efficiency and reliability in demanding environments. This cutting-edge equipment stands out for its unique combination of robust features and innovative technologies.

At the heart of the G-4.5R is its powerful engine, designed to facilitate high-performance operations. The machine is equipped with a fuel-efficient powertrain that not only maximizes output but also minimizes consumption. This feature is crucial for users who need to operate over extended periods without frequent refueling, making the G-4.5R highly suitable for long-term projects.

The G-4.5R boasts an advanced hydraulic system that enhances its lifting capabilities. With optimized hydraulic mechanics, the machine can handle heavier loads with improved precision and speed. This ensures that users can perform tasks more efficiently, reducing downtime and increasing productivity. Furthermore, the hydraulic system is complemented by a robust frame, designed to withstand rigorous field conditions while providing stability during operation.

Another notable aspect of the Stow G-4.5R is its user-centric design. The operational interface is intuitively laid out, allowing users to easily navigate controls and features without extensive training. The ergonomic design of the operating cabin further enhances comfort, reducing fatigue during long working hours. Noise reduction technologies have also been integrated into the design, making the working environment more pleasant.

In terms of technology, the G-4.5R features real-time monitoring systems that provide crucial operational data. These systems allow users to track fuel levels, hydraulic pressures, and performance metrics at a glance. Such capabilities not only promote efficient resource management but also facilitate preventive maintenance, helping to prolong the machine’s lifespan.

Safety is paramount in the design of the G-4.5R, with multiple safety mechanisms in place. These include automatic shutdown features in case of system overloads, reinforced caging to protect operators, and enhanced visibility systems that ensure a clear line of sight during operation.

In summary, the Stow G-4.5R is a versatile, powerful, and user-friendly machine specifically designed for challenging work environments. With its combination of advanced technologies, ergonomic design, and safety features, the G-4.5R stands out as a top choice for professionals aiming for efficiency and reliability in their operations.
Top Page Image Contents