Stow G-4.5R manual Operation and Safety Decals S/N 5498031 and Above

Page 15

OPERATION AND SAFETY DECALS (S/N 5498031 AND ABOVE)

 

WARNING

 

Only operate machine in well ventilated

 

areas.

 

DO NOT inhale exhaust gases.

 

S-4984

DANGEROUS

Only qualified personnel should

install, use or service this

GAS

equipment.

 

P/N 8700611804

P/N A4561000203

FUEL COCK

 

 

 

 

 

 

 

 

ON

 

MODEL

 

 

 

 

 

 

SERIAL NO.

 

 

 

 

ON

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

CONTACT

 

 

 

 

 

 

S-3704

STOW PARTS DEPT.

 

 

 

 

 

P/N 1980680004

 

 

 

 

 

DANGER

 

Do not touch output terminals or

 

internal wiring while unit is operating.

S-4985

Turn off power before servicing.

DANGEROUS

Only qualified personnel should

install, use or service this

GAS

equipment.

P/N 8700611904

CAUTION

OPERATE AT

3600 RPM ONLY

(FULL THROTTLE)

S-1123

P/N 0800628504

WARNING

To avoid injury,

you MUST read

and understand

operator’s manual

before using this

machine.

This machine to

be operated by

qualified

personnel only.

Ask for training

as needed.

P/N 35137

P/N 35137

DAMAGE MAY RESULT IF

OPERATED AT LOWER SPEEDS

P/N 7900636004

WARNING!

Before connecting this generator to any building’s electrical system, a licensed electrician must install an isolation (transfer) switch.

Serious injury or death may result without this transfer switch.

OPERATING INSTRUCTIONS

1.Before starting check the oil and fuel level.

2.Switch the circuit breaker to the “OFF” position.

3.Open the fuel valve.

4.Close the choke with the choke lever.

5.Turn the operation switch to the “ON” position

6.Pull the recoil starter.

7.After the engine starts, gradually push in the choke valve.

8.Run the generator for 3-5 minutes without load.

9.Check for any abnormal noise or smell.

10.Switch the circuit breaker to the “ON” position.

11.When stopping, remove the load for 2-3 minutes before stopping engine.

12.Turn the operation switch to the “OFF” position.

13.After the engine completely stops. Close the fuel valve.

A92120000

P/N A92120000

P/N 0820610404

 

 

ON

ON

 

 

OFF

 

 

 

IDLE

 

G-4.5R

 

CONTROL

OFF

AC VOLTMETER

120V

OPERATION

 

 

 

SWITCH

AC CIRCUIT

 

 

20A

BREAKER

 

240/120V

 

 

 

 

FULL POWER

 

120/240V

120V

SWITCH

 

 

 

20A

30A

20A

 

P/N A4511200402

Figure 2B. Operation and Safety Decals (S/N 5498031 and Above)

STOW G-4.5R A.C. GENERATOR — OPERATION & PARTS MANUAL — REV. #3 (03/13/06) — PAGE 15

Page 14 Page 16
Image 15
Page 14 Page 16
Contents Model G-4.5R Page Heres HOW to GET Help Table of Contents When ordering parts Please supply the following information Parts Ordering ProceduresDimensions Stow G-4.5R DimensionsEffects of Altitude and Heat SpecificationsStow G-4.5R Safety Message Alert Symbols Burn HazardsRespiratory Hazards Rotating Parts Hazards Equipment DamageRead this manual Stow G-4.5R Rules for Safe OperationStow G-4.5R Rules for Safe Operation Power Cord SafetyEmergencies DeathPage Machine Safety Decals Operation and Safety Decals S/N 5498030 and belowOperation and Safety Decals S/N 5498031 and Above Engine Stow G-4.5R FamilarizationControl Panel Excitation SystemSmall Motors Single Phase LoadStow G-4.5R Load Application Incandescent LoadsGenerator Controls and Components Stow G-4.5R Controls and IndicatorsStow G-4.5R Controls and Indicators Stow G-4.5R Controls and Indicators With S/N 5498031 and above Generator Refueling Stow G-4.5R Generator RefuelingMounting Stow G-4.5R InstallationOutdoor Installation Indoor InstallationConnecting the Ground Stow G-4.5R InstallationGeneral Inspection Prior to Operation Ground Power Tools Extension CableMain Circuit Breaker Fuel Check Stow G-4.5R PRE-INSPECTION EngineBefore Starting Engine Oil CheckBefore Starting the Engine Stow G-4.5R Initial START-UP EngineNoises that would associate with lose components Stow G-4.5R Initial START-UP ENGINE/OPERATION120 VAC Receptacles Main Circuit Breaker on Stopping The EngineGenerator Storage Stow G-4.5R Preparation for Long -TERM StoragePage Engine Maintenance Schedule Stow G-4.5R Maintenance EngineStow G-4.5R Maintenance Engine Cleaning the Fuel StrainerMaintenance Generator/Engine Wiring Diagram S/N 5498030 and Below Stow G-4.5R Wiring Diagram S/N 5498030 and belowStow G-4.5R Wiring Diagram S/N 5498031 and Above Stow G-4.5R -TROUBLESHOOTING Engine White Stow G-4.5R -TROUBLESHOOTING EngineGenerator Troubleshooting Stow G-4.5R -TROUBLESHOOTING GeneratorPage Items Found In the Items Number Column How to read the marks and remarks used in this parts bookTo 3 Units Stow G-4.5R Suggested Spare PartsNameplate and Decals S/N 5498030 and below Stow G-4.5R Name Plate and Decals S/N 5498030 and belowStow G-4.5R Name Plate and Decals S/N 5498030 and below Nameplate and Decals S/N 5498031 and Above Stow G-4.5R Name Plate and Decals S/N 5498030 and AboveDecal Stow Decalwarning Read ManualDecal Operating Instructions Generator Assy Stow G-4.5R Generator AssySpring Washer Field Coil AssySET BOLT, Rotor SET WASHER, BearingControl BOX ASSY. S/N 549830 and below Stow G-4.5R Control BOX ASSY. S/N 549830 and belowStow G-4.5R Control BOX ASSY. S/N 549830 and below Control BOX ASSY. S/N 549831 and Above Stow G-4.5R Control BOX ASSY. S/N 549831 and AboveStow G-4.5R Control BOX ASSY. S/N 549831 and Above HEX NUTVR1H102MHA Pipe Frame ASSY. S/N 549830 and below Stow G-4.5R Pipe Frame ASSY. S/N 549830 and belowRubber Suspension Pipe FrameSUPPORT, Pipe Frame Engine BasePipe Frame ASSY. S/N 549830 and Above Stow G-4.5R Pipe Frame ASSY. S/N 549831 and AboveWASHER, Flat HangerPlastic Washer HEX Head BoltCrankcase Assy Robin EX270D20110- Crankcase AssyBall Bearing Valve GuideStem Seal OIL SealCrankshaft and Piston Assy Robin EX270D20110 Crankshaft and Piston AssyWoodruff KEY Connecting ROD BoltCrankshaft CP Flange NUTGovernor Assy Robin EX270D20110 Governor AssyGovernor Shaft SPRING, AdjustGovernor Operation Assy Governor LeverIntake and Exhaust Assy Robin EX270D20110 Intake and Exhaust AssyRelease Lever Adjust SCREW, M5X0.5X23LPIN, CAMSHAFT, 9DX78.5L Spring PIN, 4DX7.5DX11LAIR Cleaner Assy Robin EX270D20110 AIR Cleaner AssyBody CP COVER, LOW ProfileElement Assy Cooling Starting Assy Robin EX270D20110 Cooling Starting AssyBaffle 2, Head Blower Housing CP, YellowLABEL, Trademark 64D Baffle 1, Case CPFuel Lubricant Assy Robin EX270D20110 Carburetor AssyJET Slow Screw AdjustingValve Throttle Valve ChokeFlywheel Assy Robin EX270D20110 Flywheel AssyIgnition Coil CP Wire 2 CP, W/OIL SensorSwitch Assy Flywheel CPElectric Device Assy Robin EX270D20110 Electric Device AssyClamp CP OIL Sensor CPFLOAT, C/U CP3 Tapping BoltTerms and Conditions of Sale Stow Construction Equipment Page Heres HOW to GET Help

G-4.5R specifications

The Stow G-4.5R is an exceptional piece of rugged engineering designed for professionals who require efficiency and reliability in demanding environments. This cutting-edge equipment stands out for its unique combination of robust features and innovative technologies.

At the heart of the G-4.5R is its powerful engine, designed to facilitate high-performance operations. The machine is equipped with a fuel-efficient powertrain that not only maximizes output but also minimizes consumption. This feature is crucial for users who need to operate over extended periods without frequent refueling, making the G-4.5R highly suitable for long-term projects.

The G-4.5R boasts an advanced hydraulic system that enhances its lifting capabilities. With optimized hydraulic mechanics, the machine can handle heavier loads with improved precision and speed. This ensures that users can perform tasks more efficiently, reducing downtime and increasing productivity. Furthermore, the hydraulic system is complemented by a robust frame, designed to withstand rigorous field conditions while providing stability during operation.

Another notable aspect of the Stow G-4.5R is its user-centric design. The operational interface is intuitively laid out, allowing users to easily navigate controls and features without extensive training. The ergonomic design of the operating cabin further enhances comfort, reducing fatigue during long working hours. Noise reduction technologies have also been integrated into the design, making the working environment more pleasant.

In terms of technology, the G-4.5R features real-time monitoring systems that provide crucial operational data. These systems allow users to track fuel levels, hydraulic pressures, and performance metrics at a glance. Such capabilities not only promote efficient resource management but also facilitate preventive maintenance, helping to prolong the machine’s lifespan.

Safety is paramount in the design of the G-4.5R, with multiple safety mechanisms in place. These include automatic shutdown features in case of system overloads, reinforced caging to protect operators, and enhanced visibility systems that ensure a clear line of sight during operation.

In summary, the Stow G-4.5R is a versatile, powerful, and user-friendly machine specifically designed for challenging work environments. With its combination of advanced technologies, ergonomic design, and safety features, the G-4.5R stands out as a top choice for professionals aiming for efficiency and reliability in their operations.
Top Page Image Contents