Sterling Plumbing 7104 Series manual Apply Silicone Sealant, Appliquer du mastic à la silicone

Page 28

4" (10.2 cm)

1" (2.5 cm)

1/4" (6 mm)

Bath Flange

Bride de la baignoire

Reborde de la bañera

Silicone Sealant

Mastic à la silicone

Sellador de silicona

Apply Silicone Sealant

IMPORTANT! Silicone sealant must be applied before installing the end walls.

IMPORTANT! Do not allow the silicone sealant to cure before the end walls are installed. After applying the silicone sealant, immediately proceed to the ″Secure the Wall Surrounds″ section of this guide.

NOTE: Silicone sealant can compensate for out-of-plumb walls and exposure to water at the bath flange area. The silicone sealant will be hidden when the wall surrounds are installed, and will eliminate future maintenance.

Remove the pre-fit end walls from the back wall. Set the end walls aside.

Clean and dry the outer few inches of the bath flange where the end walls will be installed.

Apply an L-shaped bead of 100% silicone sealant at each outer end of the bath flange where the end walls will be installed. Apply the bead so it is a minimum of 1/4″ (6 mm) wide and 1″ (2.5 cm) by 4″ (10.2 cm) long, as shown.

Immediately proceed to the ″Secure the Wall Surrounds″ section.

Appliquer du mastic à la silicone

IMPORTANT! Du mastic à la silicone doit être appliqué avant l’installation des murs d’extrémité.

IMPORTANT! Ne pas laisser prendre le mastic à la silicone avant l’installation des murs d’extrémité. Après avoir appliqué du mastic à la silicone, procéder immédiatement à la section ″Sécuriser les murs avoisinants″ de ce guide.

REMARQUE: Du mastic à la silicone compensera les murs qui ne sont pas d’aplomb et l’exposition à l’emplacement de la bride de la baignoire. Le mastic à la silicone sera caché lorsque les murs avoisinants sont installés et éliminera toute maintenance à venir.

Retirer les murs d’extrémité prémunis du mur arrière. Mettre les murs d’extrémité de côté.

1064912-2-A

28

Sterling

Page 27 Page 29
Image 28
Page 27 Page 29
Contents Series/Séries 7104/Serie 1064912-2-A Important Information Plus Tools/Outils/HerramientasMás Thank You For Choosing Sterling Merci d’avoir choisi SterlingGracias por elegir los productos de Sterling Before You BeginAvant de commencer Before You BeginAntes de comenzar Avant de commencerAntes de comenzar Roughing-In Raccordement71040112 71040122Diagrama de instalación Construct the FramingConstruire le cadrage Construct the FramingConstruya la estructura de postes de madera Construire le cadragePrepare the Subfloor Préparer le plancherConstruya la estructura de postes de madera Level the SubfloorPrepare el subpiso Préparer le plancherNiveler le plancher Nivele el subpisoInstaller la plomberie de raccordement Install the Rough PlumbingSeries 7104/Séries 7104/Serie Instale el tendido de tuberías Install a Mortar Cement Bed Optional Position the BathPositionner la baignoire Installer un lit de mortier OptionnelPosition the Bath Positionner la baignoire Coloque la bañeraInstale una capa de cemento mortero opcional Secure the Bath Attach the Bath to the StudsFor clip attachment For roofing nail or non-tapered flathead screw attachmentSécuriser la baignoire Fije la bañeraSecure the Bath Attacher la baignoire aux montantsFije la bañera IMPORTANT! Install the back wall first Pre-Fit the Wall SurroundsIMPORTANT! Installer d’abord le mur arrière Munir les murs avoisinantsAjuste inicial de las paredes circundantes ¡IMPORTANTE! Instale primero la pared posteriorAjuste inicial de las paredes circundantes Prepare the Wall Surrounds Préparer les murs avoisinantsFor Baths with Wall Surrounds Only Pour les baignoires avec des murs avoisinants uniquementAccessoires optionnels Prepare las paredes circundantesPréparer les murs avoisinants Sólo para bañeras con paredes circundantesPrepare las paredes circundantes Apply Silicone Sealant Appliquer du mastic à la siliconeAplique sellador de silicona Appliquer du mastic à la siliconeSecure the Wall Surrounds NecesarioFije las paredes circundantes Sécuriser les murs avoisinantsSecure the Wall Surrounds Fije las paredes circundantes Install the Finished Wall Installer le mur finiFor Bath Only Installations Installation pour baignoire uniquementComplete the Installation Installer le mur finiInstale la pared acabada Para las instalaciones de sólo bañeraCompléter l’installation Termine la instalaciónTroubleshooting Symptoms Probable Causes Recommended ActionSymptômes Causes probables Action recommandée DépannageProcedimiento para resolver problemas Care and CleaningDépannage Síntomas Causas probables Acción recomendadaEntretien et nettoyage Care and CleaningCuidado y limpieza Warranty GarantieCuidado y limpieza Years Limited Consumer/3 Years Limited CommercialGarantía Garantie1064912-2-A 1064912-2-A 1064912-2-A Phone 1-888-STERLING Mexico

7104 Series specifications

The Sterling Plumbing 7104 Series is an innovative range of bathroom fixtures designed to enhance both functionality and aesthetic appeal. Catering to modern preferences for clean lines and minimalistic design, this series includes a variety of options such as toilets, sinks, and bathtubs, each designed with the user’s comfort and convenience in mind.

A key feature of the 7104 Series is its use of high-quality materials that ensure durability and longevity. The components are made from vitreous china, known for its smooth surface and easy maintenance. This material not only resists stains and scratches but also helps to maintain cleanliness, making it an ideal choice for busy family bathrooms.

In terms of technology, the Sterling Plumbing 7104 Series integrates advanced flushing mechanisms that enhance performance while conserving water. The series often features a dual-flush option, allowing users to choose between a light flush for liquid waste and a full flush for solid waste. This not only promotes water efficiency but also aligns with contemporary eco-friendly practices, appealing to environmentally conscious consumers.

Comfort is another hallmark of the 7104 Series. Toilets feature ergonomic designs, providing optimal height and bowl shape that caters to the needs of all users. Additionally, the series’ sinks come in various styles, including undermount and pedestal options, ensuring versatile configurations to fit different bathroom layouts.

Installation and maintenance are simplified with the Sterling Plumbing 7104 Series. The products are designed for straightforward installation, with clear instructions and essential mounting hardware included. Moreover, the fixtures are engineered to minimize the need for repairs, thereby reducing long-term maintenance efforts for homeowners.

Overall, the Sterling Plumbing 7104 Series stands out in the market for its combination of style, efficiency, and practicality. With an emphasis on user experience, it incorporates modern technologies and materials that not only look great but also function exceptionally well, making it a worthwhile investment for any bathroom renovation or new build project.
Top Page Image Contents