Sterling Plumbing 7104 Series manual Roughing-In, Raccordement, 71040112, 71040122

Page 8

2" (5.1 cm) Min Drain Hole Clearance through Wall for AFD Version

Espace min d'orifice du drain de 2" (5,1 cm) à travers le mur pour la version AFD

2" (5,1 cm) de espacio mínimo para el orificio del desagüe a través de la pared para la versión del desagüe arriba del nivel del piso

Drain Cutout

 

 

60" (152.4 cm)

 

14"

 

Découpe du drain

 

 

 

(35.6 cm)

H

Abertura del desagüe

30" (76.2 cm)

 

 

5-1/2"

 

 

14"

(14 cm)

 

 

(35.6 cm)

21"

9-1/8" (23.2 cm)

 

 

 

 

(53.3 cm)

 

6"

 

 

8"

(15.2 cm)

30"

 

14"

 

(20.3 cm)

 

(76.2 cm)

 

 

(35.6 cm)

 

 

 

 

4" (10.2 cm)

 

3"

 

3-1/2" (8.9 cm)

 

 

 

(7.6 cm)

 

2" (5.1 cm) D.

71040112

 

Drain/Drain/Desagüe

 

71040122

 

 

 

 

60" (152.4 cm)

3" (7.6 cm)

 

30"

(76.2 cm)

71040110

71040120

76-3/4"

(194.9 cm)

71040112

71040122

79"

(200.7 cm)

Recommended Support Clip or Roofing Nail Location (5 Total)

Emplacement recommandé pour le clip de support ou clou pour toiture (5 Total) Lugar recomendado para el clip de sujeción o clavo de techar (5 en total)

Roughing-In

IMPORTANT! All dimensions are nominal. The stud opening tolerance is +1/8″ (3 mm)/-0. Carefully measure your fixture before determining enclosure size. Some shimming between the stud frame and the fixture may be required. If a firewall is required, rough-in dimensions will have to increase according to the thickness of the firewall material. Stud opening dimensions must be measured toward the exposed side of the wall material. Dimensions given in the rough-in information are crucial for proper installation. Construct the framing and plumbing accurately.

If installing this bath with a shower door, refer to the shower door manufacturer’s instructions for any special framing considerations.

Raccordement

IMPORTANT! Toutes les dimensions sont nominales. L’espacement du montant est de +1/8″ (3 mm) /-0. Mesurer soigneusement votre appareil avant d’en déterminer la taille de son logement. Un calage entre le cadre du montant et l’appareil sanitaire pourrait être nécessaire. Si un pare-feu est requis, les dimensions de raccordement devront augmenter en fonction de l’épaisseur du matériau du pare-feu. Les dimensions d’ouverture des montants doivent être mesurées vers le côté exposé du matériau du mur . Les dimensions fournies dans le plan du raccordement sont cruciales pour une bonne installation. Construire le cadre et la plomberie avec exactitude.

En cas d’installation de cette baignoire avec porte de douche, se référer aux instructions du fabricant de la porte de douche pour toutes considérations particulières du cadrage.

1064912-2-A

8

Sterling

Page 7 Page 9
Image 8
Page 7 Page 9
Contents Series/Séries 7104/Serie 1064912-2-A Important Information Más Tools/Outils/HerramientasPlus Thank You For Choosing Sterling Merci d’avoir choisi SterlingGracias por elegir los productos de Sterling Before You BeginAvant de commencer Before You BeginAntes de comenzar Avant de commencerAntes de comenzar Roughing-In Raccordement71040112 71040122Diagrama de instalación Construct the FramingConstruire le cadrage Construct the FramingConstruya la estructura de postes de madera Construire le cadragePrepare the Subfloor Préparer le plancherConstruya la estructura de postes de madera Level the SubfloorPrepare el subpiso Préparer le plancherNiveler le plancher Nivele el subpisoSeries 7104/Séries 7104/Serie Install the Rough PlumbingInstaller la plomberie de raccordement Instale el tendido de tuberías Install a Mortar Cement Bed Optional Position the BathPosition the Bath Installer un lit de mortier OptionnelPositionner la baignoire Instale una capa de cemento mortero opcional Coloque la bañeraPositionner la baignoire Secure the Bath Attach the Bath to the StudsFor clip attachment For roofing nail or non-tapered flathead screw attachmentSécuriser la baignoire Fije la bañeraSecure the Bath Attacher la baignoire aux montantsFije la bañera IMPORTANT! Install the back wall first Pre-Fit the Wall SurroundsIMPORTANT! Installer d’abord le mur arrière Munir les murs avoisinantsAjuste inicial de las paredes circundantes ¡IMPORTANTE! Instale primero la pared posteriorAjuste inicial de las paredes circundantes Prepare the Wall Surrounds Préparer les murs avoisinantsFor Baths with Wall Surrounds Only Pour les baignoires avec des murs avoisinants uniquementAccessoires optionnels Prepare las paredes circundantesPréparer les murs avoisinants Sólo para bañeras con paredes circundantesPrepare las paredes circundantes Apply Silicone Sealant Appliquer du mastic à la siliconeAplique sellador de silicona Appliquer du mastic à la siliconeSecure the Wall Surrounds NecesarioSecure the Wall Surrounds Sécuriser les murs avoisinantsFije las paredes circundantes Fije las paredes circundantes Install the Finished Wall Installer le mur finiFor Bath Only Installations Installation pour baignoire uniquementComplete the Installation Installer le mur finiInstale la pared acabada Para las instalaciones de sólo bañeraCompléter l’installation Termine la instalaciónTroubleshooting Symptoms Probable Causes Recommended ActionSymptômes Causes probables Action recommandée DépannageProcedimiento para resolver problemas Care and CleaningDépannage Síntomas Causas probables Acción recomendadaCuidado y limpieza Care and CleaningEntretien et nettoyage Warranty GarantieCuidado y limpieza Years Limited Consumer/3 Years Limited CommercialGarantía Garantie1064912-2-A 1064912-2-A 1064912-2-A Phone 1-888-STERLING Mexico

7104 Series specifications

The Sterling Plumbing 7104 Series is an innovative range of bathroom fixtures designed to enhance both functionality and aesthetic appeal. Catering to modern preferences for clean lines and minimalistic design, this series includes a variety of options such as toilets, sinks, and bathtubs, each designed with the user’s comfort and convenience in mind.

A key feature of the 7104 Series is its use of high-quality materials that ensure durability and longevity. The components are made from vitreous china, known for its smooth surface and easy maintenance. This material not only resists stains and scratches but also helps to maintain cleanliness, making it an ideal choice for busy family bathrooms.

In terms of technology, the Sterling Plumbing 7104 Series integrates advanced flushing mechanisms that enhance performance while conserving water. The series often features a dual-flush option, allowing users to choose between a light flush for liquid waste and a full flush for solid waste. This not only promotes water efficiency but also aligns with contemporary eco-friendly practices, appealing to environmentally conscious consumers.

Comfort is another hallmark of the 7104 Series. Toilets feature ergonomic designs, providing optimal height and bowl shape that caters to the needs of all users. Additionally, the series’ sinks come in various styles, including undermount and pedestal options, ensuring versatile configurations to fit different bathroom layouts.

Installation and maintenance are simplified with the Sterling Plumbing 7104 Series. The products are designed for straightforward installation, with clear instructions and essential mounting hardware included. Moreover, the fixtures are engineered to minimize the need for repairs, thereby reducing long-term maintenance efforts for homeowners.

Overall, the Sterling Plumbing 7104 Series stands out in the market for its combination of style, efficiency, and practicality. With an emphasis on user experience, it incorporates modern technologies and materials that not only look great but also function exceptionally well, making it a worthwhile investment for any bathroom renovation or new build project.
Top Page Image Contents