Shindaiwa Installation and Adjustment of Spark Plug for Optimal Performance

Page 8

Assembly

Throttle Linkage and Ignition Leads All Models

Assemble and Adjust

the Throttle Cable.

1. Insert the throttle-cable housing into the

notch on the fan cover, and clamp the

ground wire terminal between the fan

Red Wire

Black Ignition

 

 

Wire

cover and the outer cable adjuster nut.

See Figure 13.

2. Tighten the two throttle cable adjuster

nuts.

IMPORTANT!

Adjust and tighten the cable nuts to allow approximately 1/4-inch free play at the throttle trigger.

3.Using finger pressure only, connect the black ignition wire from the cable tube to the red ignition wire on the powerhead. Wire routing must be as shown in the illustration with the black wire located away from the throttle cable and carburetor linkage.

4.Reinstall the engine cover and tighten the captive engine cover screw.

5.Reinstall the spark plug boot.

Cable Adjuster

Nuts

Ground

Wire

Ground Wire

Terminal

Figure 13

Reinstall the Spark

Plug Cap

CAUTION!

Routing of wiring must not interfere with throttle operation.

Image 8 Shindaiwa T230 manual Assemble and Adjust Throttle Cable
Contents T230 Grass Trimmer T230X Grass Trimmer C230 Brushcutter Introduction ContentsGeneral Safety Instructions Minimize the Risk of Fire General Safety Instructions The Properly Equipped OperatorStay Alert Safety Labels Be Aware of the Working Environment all unitsUnit Description SpecificationsPrior to Assembly Assembly Driveshaft/Powerhead All Models Assembly HandleAssembly Handlebar C230 Assembly Throttle Linkage and Ignition Leads All ModelsAssemble the Handlebar Remove the Cylinder CoverAssemble and Adjust Throttle Cable Sub-Shield T230X and C230 To Change Position Line CutterAssembly Trimmer Head C230/T230/T230X Assembly Blade C230/T230XInstall the Trimmer Head Mount the BladeExamples of 501 mixing quantities Mixing FuelFilling the Fuel Tank Stopping the Engine When the Engine StartsStarting the Engine Shoulder Strap Adjusting Engine IdleChecking Unit Condition Using a Grass Trimmer T230 Engine Operating SpeedsTrimming and Mowing Grass EdgingUsing a Brushcutter Blade C230/T230X Blade ThrustBrushcutter Handlebar Brushcutter HarnessHour Maintenance General MaintenanceDaily Maintenance 10/15-Hour Maintenance Every 50 hours of operation23055 Long Term Storage Blade SharpeningMultiple-tooth Circular Blade Shindaiwa Tornado BladeTroubleshooting Guide Possible CauseSymptom Possible Cause Remedy Manufacturers Warranty Coverage
Related manuals
Manual 20 pages 29.68 Kb