Assembly
Throttle Linkage and Ignition Leads
Assemble and Adjust
the Throttle Cable.
1.Insert the throttle cable housing into the notch on the fan cover, and clamp the black wire’s connector between the fan cover and the cable outer adjuster nut. See Figure 10.
2.Tighten the two throttle cable adjuster nuts.
IMPORTANT!
Adjust and tighten the cable nuts to allow approximately
3.Using finger pressure only, connect the black switch wire from the cable tube to the red ignition wire on the powerhead. Wire routing must be as shown in the illustration with the black wire located over the spark plug wire. See Figure 10.
Red Wire | Black Wire |
|
Spark
Plug Boot
Ignition Ground |
| |||
Lead |
| |||
Black Wire |
|
|
| |
|
| |||
Figure 10 |
| |||
|
|
|
| |
4. Reinstall the cylinder cover and tighten |
| |||
CAUTION! | ||||
the three cover screws. | ||||
Routing of wiring must not interfere with | ||||
5. Reinstall the spark plug boot. | ||||
throttle operation. | ||||
|
|
| ||
Assembly
Handle LE231
Ignition |
| Handle |
Switch | Throttle | |
|
| |
| Assembly |
|
|
| Hex Nut |
|
| Hex Nut |
Mounting Screw | Washer |
|
|
| Washer |
| Adjustment | Outer Tube |
|
| |
Figure 11 | Knob |
|
|
|
Connect the Handle to the Outer Tube.
1.Remove both screws from the handle.
2.While spreading the handle at the mounting hole, position the handle on the outer tube as shown.
3.Reinstall the two mounting screws in the handle, but do not tighten them at this time.
NOTE:
The handle is recessed to receive the hex nuts.
4.Locate the handle at the best position for operator comfort (usually about 10 inches ahead of the throttle assembly).
5.Secure the handle by tightening the mounting screw and the adjustment knob screw.