English
TROUBLESHOOTING
If a fault occurs, first check the points listed below before taking the set for repair. If you are unable to remedy a problem by following these hints, consult your dealer or service centre.
WARNING: Do not open the set as there is a risk of electric shock. Under no circumstances should you try to repair the set yourself, as this would invalidate the guarantee.
PROBLEM
–POSSIBLE CAUSE
• REMEDY
No sound/power
–VOLUME not adjusted
• Adjust the VOLUME
–Headphones connected
• Disconnect headphones
–Mains lead not securely connected
• Connect the AC mains lead properly
–Batteries exhausted/ incorrectly inserted
• Insert (fresh) batteries correctly
indication
–
• Use a finalised
–CD badly scratched or dirty
•Replace/ clean CD, see Maintenance
The CD skips tracks
–CD is damaged or dirty
• Replace or clean the CD
–SHUFFLE or PROGRAM is active
• Switch off SHUFFLE / PROGRAM
Severe radio hum or noise
–Electrical interference: set too close to TV, VCR or computer
•Increase the distance
Poor radio reception
–Weak radio signal
•FM: Direct the FM telescopic aerial for optimum reception
•MW/LW: Turn the set for optimum reception
indication
–No CD inserted
• Insert a CD
–CD badly scratched or dirty
•Replace/ clean CD, see Maintenance
–Laser lens steamed up,
•Wait until lens has cleared
Poor cassette sound quality
– Dust and dirt on the heads, etc.
•Clean deck parts etc., see maintenance
–Use of incompatible cassette types (METAL or CHROME).
•Only use NORMAL (IEC I) for recording.
Recording does not work
– Cassette tab(s) may be broken
•Apply a piece of adhesive tape over the missing tab space.
Remote control does not function properly
–Batteries exhausted/ incorrectly inserted
• Insert (fresh) batteries correctly
–Distance/ angle between the set too large
• Reduce the distance/ angle
This product complies with the radio interference requirements of the European Union.
The type plate is located on the bottom of the set.
14