Shindaiwa 81704 manual Manufacturers Warranty Coverage

Page 20

The following statement only applies to United States and its territories

Shindaiwa Corporation

Federal Emission Design And Defect Limited Warranty

Utility And Lawn And Garden Engines

Shindaiwa Corporation warrants to the initial purchaser and each subsequent owner, that this utility equipment engine (herein engine) is designed, built and equipped to conform at the time of initial sale, to all applicable regulations of the U.S. Environmental Protection Agency (EPA), and that the engine is free of defects in materials and workmanship that would cause this engine to fail to conform with EPA regulations during its warranty period. This emission war- ranty is applicable in all States, except the State of California.

For parts listed under PARTS COVERED, the dealer authorized by Shindaiwa Corporation will, at no cost to you, make the necessary diagnosis, repair, or replacement of any defective emission-related component to ensure that the engine complies with applicable U.S. EPA regulations.

Corporation during a warranty repair), alteration, accident, failure to use the recommended fuel and oil, or not performing required maintenance services,

(b)the replacement parts used for required maintenance services,

(c)consequential parts used for required maintenance services,

(d)diagnosis and inspection fees that do not result in eligible warranty service being performed, and

(e)any non-authorized replacement part, or malfunction of authorized parts due to use of non-authorized parts.

MANUFACTURERS WARRANTY COVERAGE

When sold within the U.S., this engine’s emission control system is warranted for a period of two (2) years from the date this product is first delivered to the original retail purchaser.

OWNER’S WARRANTY RESPONSIBILITIES

As the engine owner, you are responsible for the performance of the required maintenance listed in your owner’s manual. Shindaiwa Corporation recommends that you retain all receipts covering maintenance on your engine, but Shindaiwa Corporation cannot deny a warranty claim solely for the lack of receipts or for your failure to ensure the performance of all scheduled maintenance.

As the engine owner, you should however be aware that Shindaiwa Corporation may deny your warranty coverage if your engine or a part has failed due to abuse, neglect, improper maintenance or unapproved modifications.

You are responsible for presenting your engine to the nearest dealer authorized by Shindaiwa Corporation when a problem exists.

If your Shindaiwa Dealer is unable to answer questions regarding your warranty rights and responsibilities, you should then contact your Shindaiwa Distributor.

For the name and telephone number of the Shindaiwa Distributor in your area, please call Shindaiwa Inc. at (503) 692-3070 between the hours of 8:00 AM and 5:00 PM Pacific Standard Time.

PARTS COVERED

Listed below are the parts covered by the Federal Emission Design and Defect Warranty. Some parts listed below may require scheduled maintenance and are warranted up to the first scheduled replacement of that part. The warranted parts include:

1.Carburetor Internal Components

Valve Assembly-throttle, Jet, Metering Diaphragm

2.Ignition System Components

Ignition Coil

Flywheel Rotor

The emission control system for your particular Shindaiwa engine may also include certain related hoses and connectors.

LIMITATIONS

The Federal Emission Design and Defect Warranty shall not cover any of the following:

(a)conditions resulting from tampering, misuse, improper adjustment (unless they were made by the dealer or service center authorized by Shindaiwa

MAINTENANCE AND REPAIR REQUIREMENTS

You are responsible for the proper use and maintenance of the engine. You should keep all receipts and maintenance records covering the performance of regular maintenance in the event questions arise. These receipts and maintenance records should be transferred to each subsequent owner of the engine. Shindaiwa Corporation reserves the right to deny warranty coverage if the owner has not properly maintained the engine. Shindaiwa Corporation will not deny warranty repairs, however, solely because of the lack of repair, maintenance or failure to keep maintenance records.

MAINTENANCE,REPLACEMENTORREPAIROFEMISSIONCONTROLDEVICES AND SYSTEMS MAY BE PERFORMED BY ANY REPAIR ESTABLISHMENT OR INDIVIDUAL; HOWEVER, WARRANTY REPAIRS MUST BE PERFORMED BY A DEALER OR SERVICE CENTER AUTHORIZED BY SHINDAIWA CORPORATION THE USE OF PARTS THAT ARE NOT EQUIVALENT IN PERFORMANCE AND DURABILITY TO AUTHORIZED PARTS MAY IMPAIR THE EFFECTIVENESS OF THE EMISSION CONTROL SYSTEM AND MAY HAVE A BEARING ON THE OUTCOME OF A WARRANTY CLAIM.

If other than the parts authorized by Shindaiwa Corporation are used for mainte- nance replacements or for the repair of components affecting emission control, you should assure yourself that such parts are warranted by their manufacturer to be equivalent to the parts authorized by Shindaiwa Corporation in their perfor- mance and durability.

OBTAINING WARRANTY SERVICE

All repairs qualifying under this limited warranty must be performed by a dealer authorized by Shindaiwa Corporation

If any emission-related part is found defective during the warranty period, it is your responsibility to present the product to an authorized Shindaiwa dealer. Bring your sales receipts showing the date of purchase for this engine. The dealer authorized by Shindaiwa Corporation will perform the necessary repairs or adjustments within a reasonable amount of time and furnish you with a copy of the repair order. All parts and accessories replaced under this warranty become the property of Shindaiwa Corporation

To locate an authorized Shindaiwa dealer near you, contact your Shindaiwa Distributor. For the name and telephone number of the Shindaiwa Distributor in your area, please call Shindaiwa Inc. at (503) 692-3070 between the hours of 8:00 AM and 5:00 PM Pacific Standard Time.

THIS WARRANTY IS ADMINISTERED BY

Shindaiwa Inc.

11975 S.W. Herman Rd. Tualatin OR. 97062 (503) 692-3070

Shindaiwa Inc.

Shindaiwa Corporation

11975 S.W. Herman Rd.

6-2-11 Ozuka-Nishi

Tualatin, Oregon 97062

Asaminami-Ku, Hiroshima

Telephone: 503 692-3070

731-3167, Japan

Fax:

503 692-6696

Telephone: 81-82-849-2220

www.shindaiwa.com

Fax:

81-82-849-2481

©2007 Shindaiwa, Inc.

Part Number 81704

Revision 2/07

Shindaiwa is a registered trademark of Shindaiwa, Inc.

Specifications subject to change without notice.

Image 20
Contents C2510 Brushcutter C2510Introduction ContentsSafety Instructions Properly Equipped Operator Always use the proper cutting tool for the jobSafety Labels Be Aware of the Working EnvironmentProduct Description Specifications C2510Prior to Assembly Assembly Install the Cutting Attachment Shield C2510Cutting Attachment Shield Sub-Shield C2510Adjustments Handle Bar C2510 Install the handlebarAdjust Throttle Lever Free Play Reinstall the air cleaner coverInstalling a Trimmer Head Gear Case ShaftInstalling a Blade Remove the hex wrenchMixing Fuel Filling the Fuel TankStarting the Engine Examples of 501 mixing quantitiesAdjusting Engine Idle When the Engine StartsIdle Speed Adjustment Stopping the EngineCutting Grass-Units equipped with a trimmer head Checking Unit ConditionShoulder Strap C2510 Using a Blade C2510 Operating Units with a BladeHour Maintenance General MaintenanceDaily Maintenance 10/15-Hour Maintenance Every 10 to 15 hours of operation139/150-Hour Maintenance Spark Arrester Screen MaintenanceLong Term Storage Blade SharpeningShindaiwa Tornado Blade Multiple-tooth Circular BladeTroubleshooting Guide Engine does not StartAdditional Problems Manufacturers Warranty Coverage Garantía DE Servicio DE Solicitudes Continuación Diagnostico Guia Adicionales ProblemasDiagnostico Guia 18SPDiscos de Afilado Plazo Largo de AlmacenamientoMúltiples Dientes de Discos Tornado Shindaiwa DiscoGuardachispas Maya la de Mantenimiento Mantenimiento o horas 139/150 CadaShindaiwa autorizado Torsión de correctasHoras 50 Cada Mantenimiento Horas 10/15 Cada MantenimientoGeneral Mantenimiento Horas 10 Cada MantenimientoDiario Mantenimiento Cuchilla una con Unidades Operando C2510 Disco un UsandoCorte de Cabezal con Equipadas Máquinas Césped de Corte Unidad la de Condición la VerifiqueMotor del Mínima Marcha de Ajuste Motor del ParadaContinuación Motor del Arranque Mínima Marcha de AjusteMotor del Arranque Combustible de Tanque el LlenandoCombustible de Mezcla De proporción a mezclaCuchilla la Instalando Nylon de Cabezal del Instalación Continuación Ensamblaje Seguridad de tuercas las AprieteAcelerador del holgura la Ajuste Ajustes C2510 MangoEnsamblaje Ensamblar de Antes C2510 EspecificacionesProducto del Descripción Seguridad de Etiquetas Trabajo de Area del Alerta EstéEquipado Debidamente Operario El Seguridad de Instrucciones Limpios mangos los mantenga SiempreContenido Humana reproducción la Nocivos efectos otros u congénitosAlerta Mantengase Cuidado con TrabajeOrador