Product Description, Specifications C2510

Product Description

C2510 BRUSHCUTTER	Ignition
	Switch
	Throttle
	Trigger

Outer Tube

Gear Case

Cutting

Attachment Shield

Brushcutter Blade

Figure 4

Spark Plug

Throttle

Interlock

Muffler

Harness

Fuel

Tank

	Handle Bar	Using the accompanying illustrations as
	Handle Bar	a guide, familiarize yourself with this unit
		a guide, familiarize yourself with this unit
		and its various components. See Figure 4.
		Understanding your unit helps ensure top
		performance, long service life, and safer
		operation.

		WARNING!
		Do not make unauthorized modifica-
		tions or alterations to any of these units
		or their components.

Specifications C2510

C2510X dry weight
(less attachments) .	.................................................... 11.5 lb./5.2 kg
Engine model	SF2510E
Engine type	with Power Boost Chamber
Bore x stroke	1.3 x 1.1 in./34 x27 mm
Displacement	1.5 cu. in./ 24.5 cc
Maximum power	1.1 HP/0.8 kW
	@ 7500 rpm (min-1)
Fuel/oil ratio	50:1 with ISO-L-EGD or JASO FC
	class 2-cycle mixing oil*
Carburetor type	Walbro WYL, diaphragm-type
Fuel tank capacity	20.3 oz./600 ml
Ignition	One-piece electronic,
	program-controlled
Spark plug	NGK CMR5H

Air cleaner type	Non-reversible heavy-duty
	two-stage filter element
Starting method	Recoil
Stopping method	Slide switch
Transmission type	Automatic, centrifugal clutch
	w/bevel gear
EPA Emission Compliance Period**	............................. Category A

*meets or exceeds these specifications and is recommended for all Shindaiwa products.

**The EPA emission compliance referred to on the emission com- pliance label located on the engine, indicates the number of operating hours for which the engine has been shown to meet Federal emission requirements. Category C = 50 hours (Moderate), B = 125 hours (Intermediate) and A = 300 hours (Extended).

Specifications are subject to change without notice.

This unit comes fully assembled with the exception of the handlebar cutting attach- ment shield and cutting attachment.

Prior to Assembly

Before assembling, make sure you have all the components required for a complete unit and inspect unit and components for any damage.

nEngine/Outer tube assembly

nHandlebar and Throttle assembly

nCutting attachment

nKit containing cutting attachment shield mounting bracket and hardware, this owner’s/operator’s manual and tool kit for routine maintenance. Tool kits vary by model and may include a hex wrench set, a spark plug/screwdriver combina- tion wrench, and a spanner.

IMPORTANT!

The terms “left”, “left-hand”, and “LH”; “right”, “right-hand”, and “RH”; “front” and “rear” refer to directions as viewed by the operator during normal operation.