Shindaiwa EB501EPA2, 68232-94011 manual

Page 3

ATTENTION STATEMENTS

This manual contains special “attention statements” surrounded by boxes and preceded by the triangular Attention Symbol.

WARNING!

A statement preceded by the word “WARNING” contains information that should be acted upon to pre- vent serious bodily injury.

CAUTION!

A statement preceded by the word “CAUTION” contains information that should be acted upon to pre- vent damaging your machine.

Additional attention statements that are not preceded by the Attention Symbol are:

IMPORTANT!

A statement preceded by the word “IMPORTANT” is one that possesses special significance.

NOTE:

A statement preceded by the word “NOTE” contains information that is handy to know and may make your job easier.

Read and follow this manual. Failure to do so could result in serious injury.

Wear eye and hearing protection at all times during the operation of this machine.

Do not operate this machine if you are tired, ill or under the influence of alcohol, drugs, or medicine.

IMPORTANT!

The operational procedures described in this manual are intended to help you get the most from your machine and also to protect you and others from harm. These procedures are general guidelines only, and are not intended to replace any safety rules/ laws that may be in force in your area. If you have any questions regarding your EB501 blower, or if you do not understand something in this manual, your Shindaiwa dealer will be glad to assist you.

For additional information, you may also contact Shindaiwa Inc. at the address printed on the back of this manual.

WARNING!

Do not make unauthorized modifi- cations to this machine!

2

Image 3
Contents EB501 Blower Introduction ContentsPage Nomenclature Assembling the Blower SpecificationsAssembled per above, and that all Connections are tight Blower tube installation affects blowerBalance and performance! Make sure Tubes and nozzle are correctlyFuel Requirements Mixing FuelInjury Filling the Fuel TankEngine cover will be hot after blower operation Starting and Stopping the BlowerWhen the Engine Starts Adjusting Engine Idle Speed Adjusting the Harness Operating Tips Using the BlowerDirect the air stream at the inside face of the filter only Routine Maintenance Every 10 HoursMore frequently if reduced performance is noted Do not nick or perforate fuel tube with wire hookEvery 10/15 Hours Every 50 HoursEvery 135 hours of operation Hour MaintenanceStorage 30 days or longer Troubleshooting Guide Troubleshooting Guide Additional Problems Troubleshooting Guide Manufacturers Warranty Coverage Maintenance and Repair Requirements