Shark SSG-503027E, SSG-503027G, SSG-503537E, SSG-503537G, SSG-603537E, SSG-603537G Coil Removal

Page 14

OPERATOR’S MANUAL PRESSURE WASHER

14

MAINTENANCE

Coil Removal:

Removal of coil because of freeze breakage, or to clean soot from it can be done quickly and easily.

1.Disconnect hose from pump to inlet side of the coil.

2.Carefully disconnect the thermostat sensor mak- ing sure you do not crimp the capillary tube.

3.Remove burner assembly from combustion cham- ber.

4.Remove the 3-3/8" bolts from each side of coil and tank assembly (these bolts are used to fasten tank to chassis).

5.Remove fittings connected to the 1/2" pipe nipples from inlet and discharge sides of coil.

6.Remove top tank wrap, bend back insulation tabs and fold back blanket.

7.Remove bolts that hold down coil to bottom wrap.

8.Remove coil.

9.Replace or repair any insulation found to be torn or broken.

10.Remove insulation retainer plates.

Coil Reinstallation:

Reinstall new or cleaned coil by reversing Steps 9 through 1.

SHARK SSG • 97-6134 • REV. 7/05a

Image 14

Contents SSG Page Contents Owner/User Responsibility Introduction and Important Safety InformationImportant Safety Information Ground terminal before servicing Component Identification Small Assembly Instructions DipstickOperating Instructions LeverPressure Washer OPERATOR’S Thermal Pump Protection Cleaning TipsApplying Detergent & General Operating Techniques RinsingStorage Shutting Down and CLEAN-UPAfter Extended Storage Engine Maintenance Maintenance Maintenance and ServiceAir Adjustment Electrode Setting BeckettElectrode Setting Wayne Fuel Pressure AdjustmentCoil Reinstallation Coil RemovalPressure TroubleshootingProblem Possible Cause Solution LOW Operating Fluctuating Problem Possible Cause Solution Burner will notLight Machine SmokesWater Problem Possible Cause Solution LOW WaterTemperature TOO HOTExcessive Problem Possible Cause Solution OIL DrippingInstallation Vibration Delivery Line Detergent notPreventative Maintenance MaintenanceExploded View Pressure Washer OPERATOR’S Exploded View Parts List Description QTYScrew, HH, NC, 1/4 x 3/4 STL Steam Pump Parts List Steam Pump Exploded ViewItem Part no Description QTY Control Panel Parts ListControl Panel Exploded View Decal, Operating Instructions Float Tank Parts List Float Tank Exploded ViewHose & Spray GUN Exploded View Hose & Spray GUN Parts List Specifications Parts Specifications Legacy PumpEngine Controls Beckett Burner Specifications Pressure Washer Warranty