Shark SSG-503027E, SSG-503027G, SSG-503537E, SSG-503537G, SSG-603537E, SSG-603537G manual

Page 5

IMPORTANT SAFETY INFORMATION

8.High pressure developed by these machines will cause personal injury or equipment damage. Use caution when operating. Do not direct discharge stream at people, or severe injury or death will re- sult.

18. Use No. 1 or No. 2 Heating Oil (ASTM D306) only.

NEVER use gasoline in your fuel oil tank. Gasoline

is more combustible than fuel oil and could result

in a serious explosion. NEVER use crankcase or

waste oil in your burner. Burner malfunction could

result from contamination.

WARNING

USE PROTECTIVE

EYE WEAR

AND CLOTHING

WHEN OPERATING THIS EQUIPMENT.

WARNING: High pressure spray can cause paint chips or other particles to become airborne and fly at high speeds.

9.Eye safety devices, safety clothing; hand and foot pro- tection must be worn when using this equipment.

10.Never make adjustments on machine while it is in opera- tion.

19. Do not confuse gasoline and fuel oil tanks. Keep

 

proper fuel in proper tank.

20.

Protect machine from freezing.

21.

Be certain all quick coupler fittings are secured be-

 

fore using pressure washer. Coupler collar must

 

be pushed into the locked position.

22.

Do not allow acids, caustic, or abrasive fluids to

 

pass through the pump.

23.

To reduce the risk of injury, close supervision is

 

necessary when a product is used near children.

WARNING: Spray gun kicks back. Hold with both hands.

11.Grip cleaning wand securely with both hands be- fore starting the cleaner. Failure to do this could result in injury from a whipping wand.

12.Machines with spray gun should not be operated with the spray gun in the off position for extensive periods of time as this may cause damage to the pump.

13.The best insurance against an accident is precau- tion and knowledge of the machine.

14.We will not be liable for any changes made to our standard machines, or any components not pur- chased from us.

Do not allow children to operate the pressure

washer. This machine must be attended during

operation.

24. Do not operate this product when fatigued or un-

der the influence of alcohol or drugs. Keep operat-

ing area clear of all persons.

25. Protect discharge hose from vehicle traffic and

sharp objects. Inspect condition of high pressure

hose before using or bodily injury may result.

26. Before disconnecting discharge hose from water

outlet, turn burner off and open spray gun to allow

water to cool below 100°F before stopping the ma-

chine. Then open the spray gun to relieve pres-

sure. Failure to properly cool down or maintain the

heating coil may result in a steam explosion.

PRESSURE WASHER OPERATOR’S MANUAL

WARNING

KEEPWATER

SPRAY AWAY FROM ELECTRICALWIRING.

WARNING: Keep wand, hose and water spray away from electrical wiring or fatal electric shock may result.

15.Read engine safety instruc- tions provided.

16.Never run pump dry or leave spray gun closed longer than 2 minutes.

27.

Do not overreach or stand on unstable support.

 

Keep good footing and balance at all times.

28.

This machine must be attended during operation.

29.

CAUTION: Risk of injury. Disconnect battery

 

ground terminal before servicing.

17. Inlet water must be cold and clean fresh water.

SHARK SSG • 97-6134 • REV. 7/05a

5

Image 5
Contents SSG Page Contents Owner/User Responsibility Introduction and Important Safety InformationImportant Safety Information Ground terminal before servicing Component Identification Small Dipstick Assembly InstructionsLever Operating InstructionsPressure Washer OPERATOR’S Applying Detergent & General Operating Techniques Cleaning TipsThermal Pump Protection RinsingStorage Shutting Down and CLEAN-UPAfter Extended Storage Engine Maintenance Maintenance and Service MaintenanceElectrode Setting Wayne Electrode Setting BeckettAir Adjustment Fuel Pressure AdjustmentCoil Removal Coil ReinstallationPressure TroubleshootingProblem Possible Cause Solution LOW Operating Light Problem Possible Cause Solution Burner will notFluctuating Machine SmokesTemperature Problem Possible Cause Solution LOW WaterWater TOO HOTInstallation Problem Possible Cause Solution OIL DrippingExcessive Vibration Delivery Line Detergent notMaintenance Preventative MaintenanceExploded View Pressure Washer OPERATOR’S Description QTY Exploded View Parts ListScrew, HH, NC, 1/4 x 3/4 STL Steam Pump Exploded View Steam Pump Parts ListItem Part no Description QTY Control Panel Parts ListControl Panel Exploded View Decal, Operating Instructions Float Tank Exploded View Float Tank Parts ListHose & Spray GUN Exploded View Hose & Spray GUN Parts List Parts Specifications Legacy Pump SpecificationsEngine Controls Beckett Burner Specifications Pressure Washer Warranty