Shark SSG-503027E, SSG-503027G, SSG-503537E, SSG-503537G, SSG-603537E, SSG-603537G manual Dipstick

Page 7

ASSEMBLY INSTRUCTIONS

Spray

Gun

Safety

Latch

High Pressure

Hose

Pressure

Nozzle

Wand

Coupler

Pressure

Nozzle

Wand

Coupler

Wand

Collar

STEP 1: Attach the high pressure hose to the spray gun using teflon tape on hose threads.

Dipstick

STEP 4: Remove shipping cap and install oil dipstick. Check pump oil level by using dipstick or observe oil level in oil window (if equipped). Use 30 wt. non detergent oil.

STEP 2: Pull the spring-loaded col- lar of the wand coupler back to in- sert your choice of pressure nozzle.

High Pressure

Hose

Discharge

Fitting

Coupler

Collar

STEP 5: Connect the high pressure hose to the pump discharge fitting. Push coupler collar forward until secure.

STEP 3: Release the coupler col- lar and push the nozzle until the collar clicks. Pull the nozzle to make sure it is seated properly.

Cold

Water

Source

Garden

Hose

STEP 6: Connect garden hose to the cold water source.

PRESSURE WASHER OPERATOR’S MANUAL

Water

Inlet

Garden

Hose

STEP 7: Check inlet filters, remove debris, then connect the garden hose. CAUTION: Do not run the pump without water or pump dam- age will result.

SHARK SSG • 97-6134 • REV. 7/05a

7

Image 7

Contents SSG Page Contents Important Safety Information Introduction and Important Safety InformationOwner/User Responsibility Ground terminal before servicing Component Identification Small Dipstick Assembly InstructionsLever Operating InstructionsPressure Washer OPERATOR’S Rinsing Cleaning TipsApplying Detergent & General Operating Techniques Thermal Pump ProtectionAfter Extended Storage Engine Maintenance Shutting Down and CLEAN-UPStorage Maintenance and Service MaintenanceFuel Pressure Adjustment Electrode Setting BeckettElectrode Setting Wayne Air AdjustmentCoil Removal Coil ReinstallationProblem Possible Cause Solution LOW Operating TroubleshootingPressure Machine Smokes Problem Possible Cause Solution Burner will notLight FluctuatingTOO HOT Problem Possible Cause Solution LOW WaterTemperature WaterVibration Delivery Line Detergent not Problem Possible Cause Solution OIL DrippingInstallation ExcessiveMaintenance Preventative MaintenanceExploded View Pressure Washer OPERATOR’S Description QTY Exploded View Parts ListScrew, HH, NC, 1/4 x 3/4 STL Steam Pump Exploded View Steam Pump Parts ListControl Panel Exploded View Control Panel Parts ListItem Part no Description QTY Decal, Operating Instructions Float Tank Exploded View Float Tank Parts ListHose & Spray GUN Exploded View Hose & Spray GUN Parts List Parts Specifications Legacy Pump SpecificationsEngine Controls Beckett Burner Specifications Pressure Washer Warranty