Shark SSG-503027E, SSG-503027G, SSG-503537E, SSG-503537G, SSG-603537E, SSG-603537G manual

Page 6

WASHER

COMPONENT IDENTIFICATION SMALL

OPERATOR’S MANUAL PRESSURE

Quick

Coupler

Discharge

Nipple

Burner Fuel

Tank

Spray Gun

High

Pressure

Hose

Flue Adapter

Optional 7-10049

Insulation Gasket

Optional 7-01471

Water

Supply Hose (not included)

Pressure

Nozzles

Detergent

Adjustable

Valve

Thermostat

 

 

Burner

 

Switch

Hour Meter

Pump

Unloader Valve

Trigger

Nozzle Quick

Wand

Coupler

Starter Grip

6

Pump — Delivers a specific gpm to the high pressure nozzle which develops pressure.

Starter Grip— Used for starting the engine manually.

Spray Gun — Controls the application of water and detergent onto cleaning surface with trigger device. In- cludes safety latch.

Unloader Valve— Safety device which allows pres- sure to be released when spray gun is closed.

Wand — Must be connected to the spray gun.

High Pressure Hose — Connect one end to water pump discharge nipple and the other end to spray gun.

Adjustable Thermostat — Safety control which pre- vents temperatures from going above adjustable set- ting.

Note: If trigger on spray gun is released for more than 2 minutes, water will leak from valve. Warm water will discharge from pump protector onto floor. This sys- tem prevents internal pump damage.

Note: if flue adapter is installed, the burner assembly air adjustment must be adjusted.

SHARK SSG • 97-6134 • REV. 7/05a

Image 6
Contents SSG Page Contents Introduction and Important Safety Information Important Safety InformationOwner/User Responsibility Ground terminal before servicing Component Identification Small Assembly Instructions DipstickOperating Instructions LeverPressure Washer OPERATOR’S Thermal Pump Protection Cleaning TipsApplying Detergent & General Operating Techniques RinsingShutting Down and CLEAN-UP After Extended Storage Engine MaintenanceStorage Maintenance Maintenance and ServiceAir Adjustment Electrode Setting BeckettElectrode Setting Wayne Fuel Pressure AdjustmentCoil Reinstallation Coil RemovalTroubleshooting Problem Possible Cause Solution LOW OperatingPressure Fluctuating Problem Possible Cause Solution Burner will notLight Machine SmokesWater Problem Possible Cause Solution LOW WaterTemperature TOO HOTExcessive Problem Possible Cause Solution OIL DrippingInstallation Vibration Delivery Line Detergent notPreventative Maintenance MaintenanceExploded View Pressure Washer OPERATOR’S Exploded View Parts List Description QTYScrew, HH, NC, 1/4 x 3/4 STL Steam Pump Parts List Steam Pump Exploded ViewControl Panel Parts List Control Panel Exploded ViewItem Part no Description QTY Decal, Operating Instructions Float Tank Parts List Float Tank Exploded ViewHose & Spray GUN Exploded View Hose & Spray GUN Parts List Specifications Parts Specifications Legacy PumpEngine Controls Beckett Burner Specifications Pressure Washer Warranty