Shark SSG-503027E, SSG-503027G, SSG-503537E, SSG-503537G, SSG-603537E, SSG-603537G manual Lever

Page 8

OPERATING INSTRUCTIONS

Oil Dipstick

STEP 1: Check engine oil level. Oil level should be level with the bottom of the oil filler neck. Be sure the machine is level when checking the oil level. (Refer to the engine's operating manual included with machine.) We recom- mend that the oil be changed after the first 5 hours of use, then once every 50 hours. Note: Improper oil levels will cause low oil sensor to shut off engine. IMPORTANT! Do not run engine with high or low oil levels as this will cause engine damage.

Gas

Tank

STEP 2: Fill gas tank with unleaded gasoline. Do not use leaded gaso- line.

OPERATOR’S MANUAL PRESSURE WASHER

Cold

Water

Source

Garden

Hose

STEP 3: Connect garden hose to the cold water source and turn wa- ter on completely. Never use hot water.

STEP 4: Trigger the spray gun to eliminate trapped air then wait for a steady flow of water to emerge from the spray nozzle.

Fuel Valve

Lever

STEP 5: Rotate the fuel shut-off valve to the "On" position. Slide the fuel valve lever to the "ON" position. When the engine is not in use, leave the fuel valve in the "OFF" position.

8

Choke

Lever

STEP 6: Pull the choke lever out to the "Choke" posi- tion (on a warm engine, leave the choke lever in the run position). Push the choke lever to the "Closed" posi- tion. To restart a warm engine, leave the choke lever in the "Open" position.

Engine

On-Off

Switch

STEP 7: Turn the engine switch to "Start" position.

SHARK SSG • 97-6134 • REV. 7/05a

Image 8
Contents SSG Page Contents Owner/User Responsibility Introduction and Important Safety InformationImportant Safety Information Ground terminal before servicing Component Identification Small Assembly Instructions DipstickOperating Instructions LeverPressure Washer OPERATOR’S Cleaning Tips Applying Detergent & General Operating TechniquesThermal Pump Protection RinsingStorage Shutting Down and CLEAN-UPAfter Extended Storage Engine Maintenance Maintenance Maintenance and ServiceElectrode Setting Beckett Electrode Setting WayneAir Adjustment Fuel Pressure AdjustmentCoil Reinstallation Coil RemovalPressure TroubleshootingProblem Possible Cause Solution LOW Operating Problem Possible Cause Solution Burner will not LightFluctuating Machine SmokesProblem Possible Cause Solution LOW Water TemperatureWater TOO HOTProblem Possible Cause Solution OIL Dripping InstallationExcessive Vibration Delivery Line Detergent notPreventative Maintenance MaintenanceExploded View Pressure Washer OPERATOR’S Exploded View Parts List Description QTYScrew, HH, NC, 1/4 x 3/4 STL Steam Pump Parts List Steam Pump Exploded ViewItem Part no Description QTY Control Panel Parts ListControl Panel Exploded View Decal, Operating Instructions Float Tank Parts List Float Tank Exploded ViewHose & Spray GUN Exploded View Hose & Spray GUN Parts List Specifications Parts Specifications Legacy PumpEngine Controls Beckett Burner Specifications Pressure Washer Warranty