Appendix A
How to Program the Remote Control
Introduction
The Model
How to Program for TV Operation
Make sure your TV is
1.Locate the TV setup code in the tables on the pages that follow. If your TV is not listed, see Searching the Code Library.
2.Point the remote control away from the EXPLORER 2000, the TV, and the VCR.
3. On your remote control, press and hold | and | at the same |
time, until the LED on the remote blinks twice.
4.Using the remote control keypad, enter your TV’s
5.Confirm by pointing the remote control toward the TV and test the Power, Volume, and Mute functions.
Note: If you programmed the remote control to adjust the volume on your settop box rather than the volume on the TV, test only the Power function. If these functions do not operate from the remote control, enter the next TV setup code in the list by repeating this procedure from step 1.
Continued on next page
565069 Rev B | EXPLORER 2000 User’s Guide |