How to Program the Remote Control, Continued
To Search the Code Library
If none of the listed TV or VCR codes work, you can enter a code that searches the library of codes. The remote control automatically selects the proper code for your TV or VCR. Make sure your TV or VCR is powered- on before you program the remote control.
1.Point the remote control away from your TV or VCR depending on which one you are programming.
2.Do one of the following:
• | To search for TV codes, press and hold | and | at the same |
| time until the LED on the remote control blinks twice, |
| |
| or, |
|
|
• | To search for VCR codes, press and hold | and | at the same |
time until the LED on the remote control blinks twice.
Note: The LED on the remote control also blinks twice when it reaches the end of its search library.
3.Using the remote control keypad enter 991. The LED on the remote blinks twice.
4.Point the remote control toward your TV or VCR, and press 
or 
depending on which one you are programming.
• If the TV or VCR turns off, go to step 6.
or,
• If the TV or VCR remains on, repeat step 4.
5. Press | to confirm a valid code. The remote control LED blinks twice. |
6.Point the remote toward the device you programmed and
Continued on next page
565069 Rev B | EXPLORER 2000 User’s Guide |
