INTRODUCTION IMPORTANT PRECAUTIONS
ASSEMBLY
BEFORE YOU BEGIN
ELLIPTICAL OPERATION
CONDITIONING GUIDELINES
A S S E M B LY STEP 4 |
|
PEDAL ARM |
|
PEDAL ARM COVER | SCREW (J) |
SCREW (K) |
|
ROLLER WHEEL COVER |
|
A)Open HARDWARE BAG FOR STEP 4.
B)Attach the PEDAL ARM COVER using 1 SCREW (J).
C)Attach the ROLLER WHEEL COVER using 1 SCREW (K).
D)Repeat on other side.
HARDWARE BAG FOR STEP 4 CONTENTS :
A S S E M B LY STEP 5 |
|
|
| LOWER LINK ARM | LOWER |
|
| HANDLEBAR |
| TEFLON WASHERS | |
| SPACER | |
|
| |
| LOWER HANDLEBAR |
|
CONSOLE MAST | NUT (P) |
|
| BOLT (M) |
|
LOWER HANDLEBAR |
|
|
| SPACER (O) |
|
| TEFLON WASHER (N) |
|
| LOWER LINKARM |
|
A)Open HARDWARE BAG FOR STEP 5.
B)Remove
C)Slide right LOWER HANDLEBAR on CONSOLE MAST and attach by reinserting
D)Slide SPACER (O) into LOWER HANDLEBAR.
E)Place TEFLON WASHERS (N) on either side of SPACER (O). While holding TEFLON WASHERS (N) slide LOWER LINK ARM into bottom end of LOWER HANDLEBAR.
F)Insert BOLT (M) into LOWER HANDLEBAR and secure using NUT (P).
E) Repeat on other side.
IMPORTANT PRECAUTIONS INTRODUCTION
ASSEMBLY
BEFORE YOU BEGIN
ELLIPTICAL OPERATION
CONDITIONING GUIDELINES
TROUBLESHOOTING LIMITED & MAINTENANCE WARRANTY
10
SCREW (J) | SCREW (K) |
15 mm | 12 mm |
Qty: 2 | Qty: 2 |
HARDWARE BAG FOR STEP 5 CONTENTS :
BOLT (M) 60 mm Qty: 2
TEFLON WASHER (N) 28.4 mm
Qty: 4
SPACER (O) 44 mm axis Qty: 2
NUT (P)
INSIDE DIAMETER:
8mm Qty: 2
11
LIMITED TROUBLESHOOTING WARRANTY & MAINTENANCE
7/7/08 4:29:18 PM |
