Scotts S2546 manual M40161

Page 20

OPERATING MOWER

Adjusting Mower Gage Wheels

Adjusting Mower Level (Side-to-Side)

cCAUTION: Avoid injury, before you adjust gage

wheels: STOP engine, remove key, and wait for blades to STOP.

IMPORTANT: Avoid machine damage. Mower gage wheels must not ride on ground to support mower weight. Adjust gage wheels each time you change cutting height.

1.Check tractor tire pressure. Inflate tires to the correct pressure. (See Checking Tire Pressure in Service - Miscellaneous section.)

2.Raise mower lift lever to TRANSPORT (upper) position and adjust cutting height. (See Adjusting Cutting Height in this section.)

D

 

C

A

 

 

B

 

M88571

3.Remove bolt (A), bushing (B), washer (C), and nut (D).

4.Move lift lever down to desired MOWING position.

5.Move mower gage wheels, one on each side, to one of four holes for desired position. On 46-Inch Mower Deck, move front and rear gage wheels.

6.Bottom of gage wheels should be approximately 6-13 mm (1/4-1/2 in) from the ground when properly adjusted.

7.Install bolt and tighten with nut.

cCAUTION: Avoid injury, before you adjust

mower: STOP engine, remove key, and wait for blades to STOP.

Be careful, sharp edges on mower blades. Always wear gloves when handling mower blades.

NOTE: A deck leveling gauge (Part Number TY15272) to aid in deck leveling may be obtained through your local Authorized Service Center at a nominal cost.

1.Park tractor on a hard, level surface.

2.Stop engine and remove key.

3.CHECK: Tire pressures must be correct. (See Checking Tire Pressure in Service – Miscellaneous section.)

4.Adjust cutting height to middle position.

AA

5.Turn left blade parallel to tractor axle. Hold drive belt and turn right blade parallel to axle.

A

M40161

6.Measure from each outside blade tip (A) to the level surface. The difference between measurements must not be more than 3 mm (1/8 in).

Operating Mower - Page 17

Page 19 Page 21
Image 20
Page 19 Page 21
Contents OPERATOR’S Manual Introduction Thank YOU for purchasing a Scotts productTable of Contents Identify Parts AssemblyConnect and Check Battery Checking Tire Pressure Tire Size Pressure-kPa psiSafety Signs Safety-Alert SymbolMachine Safety Labels CertificationPicture Note Located on Left-Hand side of deck Picture Note Located on Battery under seatPicture Note Located on Right-Hand side of deck Controls Tractor ControlsPark Safely Operating MachineOperate Safely Avoid Tipping Keep Riders Off Wear Appropriate ClothingTransport Safely Adjusting SeatUsing the Park Brake Cold Weather Starting Tips Using Throttle ControlStarting Engine Using Travel Controls Warming and Idling EngineStopping Engine Disengage mower or attachment before backing upUsing Reverse Implement Option To Travel in ReverseDaily Operating Checklist Testing Safety SystemsPushing Machine TestTest Avoid Damage to Plastic and Painted Surfaces Avoid Using Ground Engaging Equipment Using Front WeightsUsing Rear Wheel Weights Using Tire ChainsAdjusting Cutting Height Operating MowerOperate Mower Safely Check Ground ConditionsM40161 Adjusting Mower Level Front-to-Rear Disengaging Mower Engaging and Disengaging MowerDismounting to Inspect or Unplug Mower or Optional Bagger Replacement Parts John Deere QualityParts for Tractor Parts for Mower Decks Inch DeckAvoid Injury From Contacting Blades Service Machine SafelyPractice Safe Maintenance Service Interval Chart Service IntervalsService Record Service Engine Adjusting CarburetorAvoid Fumes Engine OilMake sure engine is Cold when checking engine oil level Checking Engine Oil Changing Engine Oil and FilterChecking and Cleaning Air Cleaner Elements Service precleaner Checking Spark PlugsReplacing Fuel Filter Service Steering and Brakes GreaseWheel Spindles Axle PivotAdjusting Brakes Service Mower Avoid Injury From Contacting Blades GreaseAdjusting Mower Belt Tension Replacing Mower Drive BeltAdjusting Spindle Brake Checking Mower Blades Servicing Mower BladesSharpening Blades Balancing BladesService Electrical Checking the BatteryClean Battery and Terminals Removing and Installing the BatteryCharging the Battery Using Booster Battery Replacing Headlight BulbReplacing Fuse Service Miscellaneous FuelUsing Clean Fuels Using Fresh Fuel and StabilizersOctane Rating Fuel BlendsRepair Care for Plastic and Painted SurfacesAvoid Damage Service Miscellaneous Removing Mower Removing MowerInstalling Mower Installing MowerPicture Note Front of left hand front wheel shown Picture Note Left side of tractor shownInstalling Mower Engine TroubleshootingUsing Troubleshooting Chart Troubleshooting Mower Troubleshooting Storing Machine Storing SafelyPreparing Machine for Storage Preparing Engine For StorageRemoving Machine From Storage Electrical System SpecificationsDimensions Tires Mower DeckRecommended Lubricants Cutting Width mm 46Warranty Limited Warranty for NEW Scotts Brand ProductsTire Warranty Limited Engine WarrantyWarranted Parts Limited Battery Warranty To Secure Warranty ServiceIndex GreaseRemoving Mower Reverse Implement Option, Using Title Number Price Qty Total Service LiteratureOrder Form Page Page Investment in Quality Refer to your operator’s manualContact your dealer Call the Customer Communications Center

S2546 specifications

The Scotts S2546 is an innovative lawn tractor that has been designed to provide homeowners with a reliable and efficient gardening solution. With a powerful 24 horsepower engine, this machine can manage various lawn care tasks, making it ideal for medium to large yards. It combines performance with ease of use, ensuring that even novice users can operate it effectively without prior experience.

One of the key features of the Scotts S2546 is its 46-inch cutting deck. This spacious deck allows for wider mowing paths, reducing the time spent on mowing and making it perfect for larger lawns. The cutting height can be easily adjusted through a simple lever, offering a range of heights from one to four inches. This flexibility helps users achieve the desired lawn appearance while promoting healthy grass growth.

The S2546 incorporates advanced technologies to enhance mowing performance. Its auto transmission system delivers a smooth driving experience, allowing users to adjust speed easily with just a push of the pedal. This feature provides optimal control while navigating through various terrains and obstacles in the yard. Additionally, the tight turning radius of this lawn tractor enables easy maneuverability around garden beds and trees.

Another standout characteristic of the Scotts S2546 is its user-friendly design. The comfortable high-back seat provides ample support, reducing fatigue during long mowing sessions. The intuitive control layout places all essential functions within easy reach, making it simple for users to maintain focus on their mowing tasks. Furthermore, the onboard storage compartments offer convenient space for tools and accessories, keeping everything organized and ready for use.

Safety features are also a priority in the S2546, with an automatic engine shut-off if the operator leaves the seat, preventing accidents. The durable construction of the tractor ensures that it can withstand the rigors of regular use, while the powder-coated finish protects against rust and weathering.

In summary, the Scotts S2546 lawn tractor stands out due to its robust engine, expansive cutting deck, and user-friendly design. With advanced technology, enhanced safety features, and a focus on comfort and control, it is a dependable choice for homeowners looking to maintain their lawns efficiently and effectively. Whether mowing, mulching, or bagging, the S2546 delivers an exceptional lawn care experience.
Top Page Image Contents