MTD 616 Systems Indicator Monitor If Equipped, Electric PTO Blade Engage, PTO Blade Engage Lever

Page 14

4

Operating

Your Lawn

Tractor

The PTO (Blade Engage) knob (or lever) must be in the disengaged (OFF) position when starting the engine, when traveling in reverse and if the operator leaves the seat.



Figure 4-4

Systems Indicator Monitor (If Equipped)

LCD

Located in the center of the tractor’s console, the systems indicator monitor records, and displays on its LCD, hours of tractor operation whenever the ignition key is rotated out of the STOP position.

The Indicator Monitor will also remind the operator of maintenance intervals for changing the engine oil. The LCD will alternately flash the recorded hours, “CHG” and “OIL” for five minutes, after every 50 hours of recorded operation elapse. The maintenance interval lasts for two hours (from 50-52, 100-102, 150-152, etc.). The LCD will also flash as described above for five minutes every time the tractor’s engine has been started during this maintenance interval. Before the interval expires, change the crankcase oil level as instructed in this Operator’s Manual.

Brake

If the Brake light illuminates when attempting to start the tractor’s engine, depress the brake pedal.

PTO (Blade Engage)

If the PTO light illuminates when attempting to start the tractor’s engine, move PTO lever (or button) into the disengaged (OFF) position.

Oil

It is normal for the Oil light to illuminate while the engine is cranking during start-up, but if it illuminate’s during operation, while the engine is running, stop the tractor immediately and check the crankcase oil level as instructed in this Owner’s Manual.

Battery

It is normal for the Battery light to illuminate while the engine is cranking during start-up, but if it illuminate’s during operation, while the engine is running, the battery is in need of a charge or the engine’s charging system is not generating sufficient amperage. Refer to

the MAINTENANCE section of this manual for the proper battery charging procedure or have the charging system checked by your service dealer.

The ammeter (if so equipped) measures the electrical output of the engine’s charging system. Under normal operating conditions, with the engine at full throttle, the ammeter’s needle should measure a positive charge. The hour meter (if so equipped) operates whenever the engine is running and records the actual hours of tractor operation.

Electric PTO

(Blade Engage)

Knob (If Equipped)

To engage the power to the cutting deck or other (sepa-

rately available) attachments on models equipped with an electric PTO, pull outward on the PTO (Blade Engage)

knob. Push the PTO (Blade Engage) knob inward to disengage the power to the cutting deck.

NOTE: The PTO (Blade Engage) knob must be in the disengaged (OFF) position when starting the engine, when traveling in reverse and if the operator leaves the seat.

PTO (Blade Engage) Lever

On models equipped with a manual PTO (Blade Engage), the PTO (Blade Engage) lever is located on the left side of the dashboard next to the steering wheel. Move the PTO (Blade Engage) lever forward to engage the power to the cutting deck or other (separately available) attachments; move the PTO (Blade Engage) lever rearward to disen- gage the power to the attachments.

��

��� ���

04/  ",!$% %.'!'%

NOTE: The PTO (Blade Engage) lever must be in the disengaged (OFF) position when starting the engine, when traveling in reverse and if the operator leaves the seat.

Seat Adjustment Lever (If Equipped)

To adjust the seat forward or backward on units equipped with a quick-adjust seat, slide the seat adjustment lever to the left and reposition the seat to the desired position. Once a comfortable position is found, release the seat adjustment lever to lock the seat in place. Refer to the Adjusting Your Lawn Tractor section of this manual for more detailed instructions on all seat adjustments.

14

Page 13 Page 15
Image 14
Page 13 Page 15
Contents OPERATOR’S Manual Table of Contents Slope Gauge Use only an approved gasoline container Replace gasoline cap and tighten securelyGeneral Operation This manual and on the machine Slope Operation Never allow children or others in or on towed equip- mentService Gas and Oil Fill-up Setting Up Your Lawn TractorAttaching the Battery Cables Remove the hex bolt and wing nut from the negative cableShipping Brace Removal Attaching The Steering WheelKnob Adjustment Seat Standard Adjustment SeatQuick Adjustment Seat Attaching The SeatIdentifying the Mulch Plug If so equippedOperating Your Lawn Tractor Brake PedalChoke Control Ignition Switch ModuleThrottle Control Lever Brake PedalElectric PTO Blade Engage Systems Indicator Monitor If EquippedSeat Adjustment Lever If Equipped PTO Blade Engage LeverDeck Lift Lever Safety Interlock SwitchesReverse Caution Mode Parking Brake ButtonStarting the Engine Setting the Cutting HeightEngaging the Parking Brake Driving On Slopes Stopping the EngineDriving The Tractor Drive PedalMoving the Tractor Manually Setting The Cruise ControlUsing the Deck Lift Lever Engaging the BladesMulching If Equipped MowingHeadlights Front To Rear Adjusting Your Lawn TractorLeveling the Deck Side to SideSteering Adjustment Parking Brake AdjustmentSeat Adjustment Quick Adjust Seat If so equippedKohler Single Shown Cleaning the Engine And DeckMaintaining Your Lawn Tractor EngineMove the tractor’s PTO Blade Engage into the OFF position Cutting Deck RemovalDeck Wash System If equipped Repeat steps 4-11 on the opposite side of the cutting deckBattery TiresCutting Blades FusesChanging the Lower Deck Belt 46 Decks Changing the Deck BeltChanging the Transmission Drive Belt Belt Cover Inch Two-stage Snow Thrower Rear Wheel Weight KitFor an extended period Storing your tractor Inch Deck Mulch KitYour Responsibility Housing Spark plug wires looseClean pre-cleaner, if so equipped Wide Dirty air cleanerWarranty 06.18.06Drive Belt Transmission 734-1731

616 specifications

The MTD 616 is a versatile and powerful ride-on mower that stands out in the landscaping equipment market due to its robust design and innovative technologies. This machine is particularly well-suited for residential and light commercial users, offering an exceptional combination of performance, comfort, and efficiency.

One of the main features of the MTD 616 is its durable build quality. A strong steel frame ensures the mower can withstand demanding conditions, while a wide cutting deck allows for efficient mowing of larger areas. The mower typically features a 42-inch deck, which strikes a perfect balance between cutting width and maneuverability, making it ideal for both open lawns and more confined spaces.

The MTD 616 is powered by a reliable engine, usually a gas-powered unit, providing sufficient torque and power to handle various grass types and terrains. This ensures that users can tackle thick grass and uneven ground without issues. The mower's transmission system is designed for smooth operation, often featuring an automatic or hydrostatic transmission that enables seamless speed adjustments while mowing.

In terms of user comfort, the MTD 616 is equipped with an ergonomic seat and intuitive controls, making it easy for operators to navigate and operate the mower efficiently. The machine's adjustable cutting height allows users to customize their mowing experience, accommodating different grass lengths and varying seasonal growth patterns.

Additionally, the MTD 616 highlights advanced technologies aimed at enhancing functionality. Some models incorporate a mulching feature, which helps in returning cut grass to the lawn as nutrient-rich mulch, promoting healthier growth. Other models may offer bagging options for easy collection of clippings, keeping the lawn tidy.

Safety is an important consideration, and the MTD 616 typically includes features such as a blade brake that stops the mower blades when the operator leaves the seat, ensuring greater safety during operation. Furthermore, its compact design and tight turning radius enhance maneuverability, making it suitable for navigating around landscaping features and garden beds.

Overall, the MTD 616 stands out as a formidable choice for users seeking a reliable and efficient ride-on mower. Its combination of robust construction, advanced features, and user-friendly design positions it as an excellent investment for maintaining a beautiful and well-manicured lawn. Whether it’s for homeowners or light commercial use, the MTD 616 offers the performance and versatility needed for effective grass management.
Top Page Image Contents