OPERATION
STORAGE (GBW/GBWE)
Before storing the GBW/GBWE Lighting System, perform the following steps.
NOTICE
Allow about 15 to 20 minutes for the lamp to cool down before storing the GBW/GBWE.The possibility exists of the balloon getting burned if it touches a hot lamp.
1.Disconnect the lamp connector from the AC power cable.
2.Unhook the AC power cable from the eyelet at the bottom of the balloon.
3.Make sure the mast is completely lowered as described in LOWERING THE MAST section.
4.Lock the buckle to secure the balloon together.
5.Unzip the zipper on the protective cover and pull down cover over the balloon/lamp assembly.
6.Place the AC power cable in the pocket inside the protective cover and attach velcro tabs.
7.Loosen the
8.Lift mast while pulling up strap (Figure 31).
LATCH
UPPER
POSITION
LOWER
POSITION
Figure 31. Unlocking the Latch
9.Continue pulling upward on the mast until all the pentapod legs are fully retracted and are stowed. See Figure 32.
STRAP
PENTAPOD
STOWED
Figure 32. Stowing the Pentapod
10.Once pentapod legs are all in stow position, wrap strap around all fi ve legs and secure by locking the buckle. See Figure 33.
STRAPBUCKLE
Figure 33. Locking Up Stowed Pentapod
11.Place the stowed pentapod inside the carrying case. See Figure 34.
CARRYING
CASE
STOWED 
PENTAPOD
Figure 34. Storing in Carrying Case
GLOBUG LIGHTING SYSTEM • OPERATION AND PARTS MANUAL — REV. #0 (07/23/09) — PAGE 25