4.Insert the ignition key into the ignition (Figure 14), place key in the start position, when engine starts release key.
Figure 14. Ignition Switch
5.Iftheenginedoesnotstart,repeatsteps1through4 or consult the troubleshooting guide contained in this manual.
6.Let the engine warm for 3 to 5 minutes before using roller. Check for fuel and oil leaks, and noises that would asso- ciate with a loose guard and/or covers.
7.If necessary return the choke knob to the full OPEN position.
OPERATION
1.Release the parking brake by pushing down on the parking brake lever.
2.To make the roller move in a forward direction, move the transmission control lever forward as shown in Figure 15. Make sure lever is securely place into notch.
R2000H — OPERATION
Figure 15. Traveling Forward
3.The speed of the roller is directly proportional to the amount ofpressurebeingappliedtotheleverineachdirection.Travel speed is between 0 and 4 mph (6.4 kph).The transmission controllevermaybemovedforwardorreverseatanyengine speed.However, it should not be moved rapidly as damage to the drive train may result.
4.Furtheradjustmentoftravelspeedcanbemadebychanging engine throttle setting. Maximum speed is attained with maximum engine speed and full forward or reverse lever position. Maximum power is attained with lever just out of neutral position and maximum engine speed
WARNING
Transmission control lever must be in neutral position when starting engine. NEVER engage transmission abruptly because this places unnecessary high loads on all drive line components.
WARNING
The parking brake must be used to hold the roller in the "stopped" condition. The transmission system will not hold the roller in a "stopped" condition.
To slow or stop roller, move the transmission control lever toward
NOTE the neutral position. If roller still cannot be slowed or stopped using the hydraulic braking sys- tem, use the parking brake to slow and then stop the roller.
PAGE 24