Multiquip DCA-220SSVU 50 HZ Generator Outputs, Generator OutputVoltages, Generator Amperage

DCA-220SSVU (50 HZ) — GENERATOR OUTPUTS

Generator OutputVoltages

A wide range of voltages are available to supply voltage for many different applications. Voltages are selected by apply- ing jumpers (6) to the voltage change-over board (Figure 15). To obtain some of the voltages as listed in Table 6 (see below) will require a fine adjustment using the voltage regu- lator (VR) control knob located on the control panel.

Voltage Change-Over Board

The voltage change-over board (Figure 15) is located on the control box, behind the generator control panel. This board has been provided for ease of voltage selection.

Generator Amperage

Tables 8 describes the generator’s current output capability for 3Ø phase applications.

Table 8. Generator Ampere Ratings ⎯ 3∅

KW	200V	400V
20	72	36
40	144	72
60	216	108
80	288	144
100	360	180
120	433	216
140	505	252
160	576	288

Figure 15. Voltage Change-Over Board

CAUTION - CHANGINGVOLTAGES

NEVER attempt to place jumper plates on the voltage change-over board while the generator is in operation. There exist the possibility of electrocution, electrical shock or burn, which can cause severe bodily harm or even death!

Table 7. Voltages Available

Three Phase	200V	220V	240V	416V	440V
Single Phase	115V	127V	139V	240V	254V

Maximum Amps

Table 9 shows the maximum amps the generator can pro- vide. DO NOT exceed the maximum amps as listed.

Table 9. Generator Maximum Amps

Model	DCA220SSVU
Rated Voltage	Maximum Amps
Single Phase	533 amps (4 wire)
100 Volt
Single Phase	266 amps (4 wire)
200 Volt
Three Phase	577 amps
200 Volt
Three Phase	288 amps
400 Volt

PAGE 28 — DCA-220SSVU (50 Hz) — OPERATION AND PARTS MANUAL — REV. #0 (04/18/06)