Throttle

FIGURE 13.

THROTTLE CONTROL

The throttle control is used to regu late the eng ine speed and to activate the choke on the engine. To get maximum efficiency from cutting, the throttle should be in the FAST position when operating the mower. Pushing the throttle all the way for- ward past FAST, will choke the engine. See figure

14.	,--	~
	t'~

Liftan~

Control~k..==!J/:,

Light Ignition

Switch Switch

Gear Shift

Lever

FIGURE 14.

Place steering wheel and bellow on the steer- ing shaft, lining up the flats in the wheel with the flats on the shaft.4.

Secure with belleville washer (6) (cupped side against the steering wheel) and hex nut (C).

~See figure 12.

5.Press the steering wheel cap (A) on the steer- ing wheel by hand.

SEAT INSTAllATION

The seat may be adjusted to four different posi. tions. Select desired position and secure seat to seat spring with lock washer (l) and hex nut (M). A 3/4" or adjustable wrench is required. See figure

13.

GEAR SHIFT LEVER

The gear shift lever is used to shift into one of the forward gears, "NEUTRAL" or "REVERSE." See figure 14. Model TMO-33902A has three forward gears. Model TMO-33886C has fivE forward gears.

IGNITION SWITCH

Turn the key to the "START" position to start the engine. When the engine is running, let the key return to the "ON" position. To stop the engine, turn the key to the left to the "OFF" position and remove it to prevent accidental starting. See figure 14.

LIGHT SWITCH

Push the light switch to turn on the lights. The lights will only operate when the engine is run- ning. See figure 14.

AMMETER

The ammeter registers the rate of battery charge or discharge. The ammeter will register on the

discharging side when starting the engine. It should register on the opposite side (charging) when the engine is running in the fast position un- til the battery is completely charged. With a fully charged battery or with the engine idling, the am- meter will not show a charge. See figure 14.