Minelab 4901 - 0059 Assembling Your X-TERRA, List of Parts, Connecting the Coil, Shaft Assembly

4ASSEMBLING YOUR X-TERRA 70

List of Parts

Before assembling your X-Terra 70, please check that the package includes these parts:

Coil

Skidplate (fitted to coil)

Lower shaft

Middle shaft

Upper shaft

Armrest

Stand

Control box

Rubber washers (2)

Plastic wing nut

Plastic bolt

Armrest screw

Armrest strap

Velcro tabs (2)

Warranty card

Instruction manual

you’re holding it :-)

5

Connecting the Coil

Plug the two rubber washers into the holes on either side of the lower shaft yoke.

Slide the yoke into the yoke bracket on top of the coil. Ensure that the spring loaded pin in the lower shaft is underneath the coil shaft, pointing downwards.

Insert the plastic bolt through the yoke and the yoke bracket.

Fasten with the plastic wing nut provided, being careful not to damage the thread of the bolt by over-tightening. This may need to be loosened to adjust the coil to a comfortable detecting angle.

The coil cable is directly wired into the coil and is not removable. Any attempt to disconnect this cable will void your warranty.

Shaft Assembly

Ensure that the twistlocks of the shafts are loosened by rotating them counter- clockwise.

Compress the spring loaded pin in the lower shaft and slide it into the middle shaft until the pin reaches the adjust- ment holes. The pin will spring out and click into place.

Attach the middle shaft to the upper shaft in the same way.

Once shafts are assembled, lock them in position by rotating twistlocks clockwise.

The upper shaft assembly location uses two spring loaded pins to strengthen the joint, one on either side of the shaft.