
ENGLISH | CONNECTIONS |
|
WIRING SPEAKER CABLE
• Peel off the coating of speaker cable as shown below.
Approx. 1 cm
Cut the coating | Peel off the edge | Twist conductors. |
of cable. | of cable. |
|
• Wiring with speaker cable.
Turn counter- | Insert conductor | Turn clockwise to |
clockwise to loosen. | of cable. | tighten. |
• Wiring with “Y” style terminal
Turn counter- | Insert conductor. | Turn clockwise to |
clockwise to loosen. |
| tighten. |
Your speaker system needs to meet the following requirements. If speakers that do not meet the following requirements are used, the amplifier protective circuit may trip, and sounds will not playback correctly. In certain cases, damage may also be caused to the amplifier and speaker system.
•If using 1 set of speakers, total speaker impedance must be 4Ω or more.
•If using 2 sets of speakers, total speaker impedance must be 8Ω or more.
•When using the speaker system in BTL mode, use a speaker system that has an impedance of 8Ω or higher.
Notes:
•To prevent damage to circuitry, do not let the bare speaker wires touch each other and do not let them touch any metal part of this unit.
•Do not touch the speaker terminals when the power is on. It may cause you to receive an electric shocks.
•Do not connect more than one speaker cable to one speaker terminal. Doing so may damage this unit.
•Be sure to connect the positive and negative cables for the speaker properly. If they are
8