Marantz SR7001, SR8001 manual Hdmi, Troubleshooting, Cppm, Symptom Cause Remedy

ENGLISH

HDMI

	SYMPTOM			CAUSE		REMEDY
The display does not			The connected monitor or projector
appear over an HDMI			does not support HDCP.
connection.
			The HDMI input of on the TV is			Set HDMI input so that it turns on, as
			not on.			explained in the TV's instruction manual.
			The HDMI output on the source			Set HDMI output so that it turns on, as
			component (DVD, Set Top Box,			explained in the source component's
			etc.) is not on.			instruction manual.
			The HDMI mode is not correctly			Set HDMI input on the FUNC INPUT
			set on the SR7001/SR8001.			SETUP menu as explained on page 25.
			The HDMI output video resolution			Set the resolution so that it matches, as
			of the source component (DVD,			explained in the instruction manuals of both
			Set Top Box, etc.) does not match			components.
			the TV specifications.
			The device is connected with a			A 5 m or shorter cable is recommended to
			non-standard HDMI cable.			ensure stable operation and prevent image
						quality deterioration.
			Power to the SR7001/SR8001 is			Turn on the power to the SR7001/
			off. (When the SR7001/SR8001			SR8001.
			is on standby, HDMI connections
			cannot be turned on.)
			The	connection	between	Shut off and then turn the power back on
			HDMI	components	was not	to the SR7001/SR8001, TV and source
			authenticated.			component.
Time is needed for the			The	connection	is being	There is nothing wrong with the system.
display of an		HDMI	authenticated between the HDMI			Some HDMI devices require time for
connection to appear.			devices.			authentication.
Audio	is not	played	The HDMI audio output of the			Set the HDMI audio output so that it turns
back	over an	HDMI	source component (DVD, Set			on, as explained in the source component's
connection.			Top Box, etc.) is not on.			instruction manual.
			The signal format of the source			Set the HDMI audio output so that it
			component (DVD, Set Top Box,			can connect to the SR7001/SR8001,
			etc.) is not supported by the			as explained in the source component's
			SR7001/SR8001.			instruction manual.
			The SR7001/SR8001 is set to			In the “THROUGH” mode, sound is not
			the HDMI audio “THROUGH”			produced from the SR7001/SR8001. Set it
			mode.			to “ENABLE”. (see page 36)
DVD-Audio is not played			The DVD player does not support			• Use a DVD-Audio player that supports
back	over an	HDMI	CPPM, therefore it cannot output			CPPM.
connection.			HDMI audio.			• Turn on PCM downsampling on the DVD
						player.
						• Use an analog connection.

TROUBLESHOOTING

If a problem should arise, first check the following.

1.Are the connections correct?

2.Have you operated the receiver according to the operating instructions?

3.Are the speakers and other components operating properIy?

If this unit is not operating properly, Check the items listed in the table beIow. Should the problem persist, there may be a malfunction. Disconnect the power immediately and contact your store of purchase.

SYMPTOM	CAUSE	REMEDY
“ANTENNA” is displayed.	XM terminal and the XM Connect-and-	Check that the connection are correct.
	Play antenna or Passport system is not
	properly connected.
“NO SIGNAL” is displayed.	The signal cannot be received.	Reposition your XM Connect-and-Play
		antenna.
Receiving only XM channels 0 and 1.	The XM Tuner is not activated.	Contact XM Radio.

68