Marantz SR8002, SR7002 manual Operation of Remote Controller, Loading Batteries

OPERATION OF REMOTE CONTROLLER

REMOTE CONTROL

Operate the remote controller within a distance of approx. 5m from the infrared receptor window on the front of the unit.

SR7002/8002

60°

LOADING BATTERIES

Before using the remote controller for the first time, load the batteries in the remote controller. The batteries provided are used to verify the operations of the remote controller only.

<RC8001SR>

1. Remove the back cover.

<RC101>

1. Remove the battery cover.

CAUTIONS ON BATTERIES		ENGLISH
• Use “AAA” type batteries in this remote controller.
• We recommend that you use alkali batteries.
•	The life of the batteries used with the remote
	controller is about 4 months with normal use.
•	If the remote controller does not operate from
	close to the unit, replace the batteries with new
	ones, even if less then a year has passed.
• The included battery is only for verifying operation.
	Replace it with a new battery as soon as possible.
• When inserting the batteries, be careful to do so in
	the proper direction, following the + and - marks in
	the remote controller’s battery compartment.
• To prevent damage or battery fluid leakage:
	- Do not use a new battery with an old one.
	- Do not use two different types of batteries.

Remote controller

Caution:

•Do not allow direct sunlight, an inverter fluorescent light or other strong source of light to shine onto the player’s infrared receptor window. Otherwise, the operation of the remote controller may be disabled.

•Bear in mind that operating the remote controller may cause other devices operated by infrared rays to be operated by mistake.

•The remote controller cannot be operated if the space between the controller and the player’s infrared receptor window is obstructed.

•Do not place any objects on top of the remote controller.

Doing so may cause one or more buttons to be held down which will cause the batteries to run down.

2.

3.

Insert the new batteries (AAA type) with correct

ªand · polarity.

Close the battery cover until it clicks shut.

2. Insert the new batteries (AAA type) with correct

ªand · polarity.

3. Close the battery cover until it clicks shut.

- Do not short-circuit, disassemble, heat or

dispose of batteries in flames.

• Remove the batteries when not planning to use the

remote controller for a long period of time.

• If the batteries should leak, carefully wipe off the

fluid from the inside of the battery compartment,

then insert new batteries.

• When disposing of used batteries, please comply with governmental regulations or environmental public instruction’s rules that apply in your country or area.

BATTERY REPLACEMENT INTERVAL (RC8001SR)

When the batteries wear out, a battery mark is displayed on the LCD. Although the remote control can still be used when the battery mark is displayed, the batteries should be replaced as soon as possible. The LCD eventually starts to flash when buttons are pressed, the remote control will be unable to transmit signals or learn codes.

•This remote control uses non-volatile memory so that the learned codes and macro programs are retained even if the batteries are removed.

•Reset the clock after replacing the batteries.

7