Jonsered GR 2126D manual Assembling the blade guard and clearing blade, Assembly

ASSEMBLY

Assembling the blade guard and clearing blade

Assembling the spray guard and trimmer head Tap´n´go Pro

•Remove the mounting plate (H). Fit the adapter

(I) and bracket (J) with the two screws (K) as shown. Fit the blade guard (A) to the adapter using the 4 screws (L) as shown.

NOTE! Use the recommended blade guard. “See Technical data“.

•Fit the drive disc (B) on the output axle.

•Turn the blade axle until one of the holes in the drive disc aligns with the hole in the gear housing.

•Insert the locking pin (C) in the hole so that the axle is locked.

•Place the blade (D) and support flange (F) on the output axle.

•Fit the nut (G). The tightening torque of the nut is 35-50 Nm (3.5 - 5 kpm). Use the socket spanner in the tool kit. Hold the handle of the spanner as close to the blade guard as possible. The nut is tightened when the spanner is turned against the direction of rotation (left- hand thread).

•When slacking off and tightening the saw blade nut, the hands may be injured by the blade teeth. Always hold your hand protected by the blade guard. This is facilitated by the use of a long box spanner. The illustration shows the area in which you should keep the box spanner.

G

F

D

B

C

•Fit the appropriate guard

(A) for use with the trimmer head. Hook the guard onto the shaft fitting and secure it with the bolt

(L).

•Fit the drive disc (B) on the output axle.

•Turn the blade axle until one of the holes in the drive disc aligns with the hole in the gear housing.

•	Insert the locking pin (C)		K
	in the hole so that the axle		J
	is locked.
			I
•	The trimmer head must be
	split to be fitted (see the		K
	diagram). Proceed as
	follows:
•	Insert your finger into the	G
		F	B
	centre hole of the cover (I)	I
			C
	at the same time as you
	hold the cover with your
	other fingers. Press the two
	catches (J) that extend from
	the cut-out on the bottom		A
	section (K) using the
	thumb and index finger of
	your other hand. Press
	apart the trimmer head
	using the fingers on the
	cover.

•Place the cover (I) and the support flange (F) on the output axle.

• Fit the nut (G). The tightening torque of the

nut is 35-50 Nm (3,5-5 kpm). Use the socket spanner in the tool kit. Hold the handle of the spanner as close to the

trimmer guard as possible. The nut is tightened when the spanner is turned against the direction of rotation (left-hand thread).

•Fit the trimmer head‘s bottom section (K) on the cover (I) by pressing the two sections together with the cut-outs on the bottom section aligned with the catches on the cover.

•To dismantle follow the instructions in the reverse order.

18 – English