Jonsered GR 2026D, GR 2032D, GR 2036 manual Cutting equipment

Page 9

SAFETY INSTRUCTIONS

6. Cutting equipment

This section describes how through correct maintenance and through using the right type of cutting equipment you can:

•Reduce the machine‘s tendency to kickback

•Obtain maximum cutting capacity.

•Increase the service life of the cutting equipment.

Four basic rules:

1)Only use the cutting and guard equipment we recommend! See chapter “Technical data“.

2)Keep the blade‘s teeth well and correctly sharpened! Follow our instructions and use the recommended filing gauge. An incorrectly sharpened or damaged blade increases the risk of an accident.

3)Keep the correct setting. Follow our instructions and use the recommended setting tool. An incorrectly set blade increases the risk of jamming and kickback.

4)Check the cutting equipment with regard to damage and crack formation. Damaged cutting equipment should always be replaced.

7. Quick-release

• Check that the harness straps are correctly positioned. When the harness and machine are adjusted, check the harness‘ safety release catch to ensure it works correctly.

8. Locking nut

• Protect your hand from injury when assembling, use the blade guard as protection when tightening with a socket spanner. Tighten the nut by turning against the direction of rotation. Loosen the nut by turning in the direction of rotation. (NOTE! the nut has a left-hand thread).

•Tighten the nut using a socket spanner, 35 - 50 Nm (3.5 - 5 kpm).

NOTE!

The locking nut‘s nylon lock must not be so worn that it can be turned by hand. The lock shall hold at least 1.5 Nm. The nut should be replaced after it has been put on approx. 10 times.

!WARNING!

Never use a machine with defective safety equipment. The safety equipment should be maintained as described in this section. If your machine does not meet any of these controls you should contact your service workshop.

English – 9

Page 8 Page 10
Image 9
Page 8 Page 10
Contents EPA Operator´s manualSymbols Symbol ExplanationContents Machine‘s safety equipment Safety InstructionsPersonal protective equipment Throttle trigger lockCutting attachment guard Stop switchAnti-vibration system Quick-releaseMuffler Cutting equipmentLocking nut Throttle trigger lock Vibration damping system Cutting equipment Sharpening the clearing blade Cutting equipmentSharpening the grass blade Trimmer headStart Fuel safety General safety instructionsTransport and storage 10 ftGeneral working instructions Basic safety precautionsAdjusting the harness and clearing saw Basic clearing techniquesDesignations Forestry clearing using a saw blade Clearing‘s ABCWorking methods Brush cutting using a grass blade Brush cutting using the saw bladeClearing Grass clearing using the trimmer head and plastic knifesTrimming SweepingWhat is what on the brushcutter? What is WHAT?Assembly Assembling the handlebars GR2036Transport position, handlebars Axle is locked Assembling the blade guard and grass bladeAssembling other guards and cutting equipment Adjusting the harness and clearing saw Fuel Handling Fuel mixtureFuelling Start and Stop Control before startingStart and stop Carburetor MaintenanceHigh speed needle H Correctly adjusted carburetor Final setting of the idling speed TCooling system MufflerAir filter Spark plug Angle gearFiling the grass blade Daily maintenance Maintenance scheduleWeekly maintenance Monthly maintenanceTechnical Data Technical dataGR 2026D GR 2032D Approved accessories GR2036 Type Cutting attachment Approved accessories GR2032D Type Cutting attachmentType Cutting attachment Guard Art No Guard Ref NoYour Warranty Rights Obligations Emission Control Warranty StatementAuto Poly Trim Click Trimmy H Trimmy SII ~ 15 cm ´*xt=¶5Q¨ Page 2002W04 108 88
Top Page Image Contents